Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   16.212946] ppdev: user-space parallel port driver
[   16.648326] iwl3945 0000:0c:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   16.875695] iwl3945 0000:0c:00.0: loaded firmware version 15.32.2.9
[   16.945709] Registered led device: iwl-phy0::radio
[   16.945749] Registered led device: iwl-phy0::assoc
[   16.945783] Registered led device: iwl-phy0::RX
[   16.945817] Registered led device: iwl-phy0::TX
[   16.969543] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   17.007732] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   19.656677] [drm] TV-14: set mode NTSC 480i 0
[   19.799293] [drm] TV-14: set mode NTSC 480i 0
[   19.989047] CE: hpet increasing min_delta_ns to 15000 nsec
[   20.212065] [drm] TV-14: set mode NTSC 480i 0
[   20.352769] [drm] TV-14: set mode NTSC 480i 0
[   25.788290] [drm] TV-14: set mode NTSC 480i 0
[   25.928476] [drm] TV-14: set mode NTSC 480i 0
[   26.211290] [drm] TV-14: set mode NTSC 480i 0
[   26.351467] [drm] TV-14: set mode NTSC 480i 0
[   26.671126] [drm] TV-14: set mode NTSC 480i 0
[   26.811664] [drm] TV-14: set mode NTSC 480i 0
[   69.745065] CE: hpet increasing min_delta_ns to 22500 nsec
[   78.874875] [drm] TV-14: set mode NTSC 480i 0
[   79.033637] [drm] TV-14: set mode NTSC 480i 0
[   79.316865] [drm] TV-14: set mode NTSC 480i 0
[   79.458550] [drm] TV-14: set mode NTSC 480i 0
[   79.750509] [drm] TV-14: set mode NTSC 480i 0
[   79.890834] [drm] TV-14: set mode NTSC 480i 0
[   83.444208] [drm] TV-14: set mode NTSC 480i 0
[   83.584335] [drm] TV-14: set mode NTSC 480i 0
[   93.194883] wlan0: authenticate with AP 00:23:f8:21:d7:f6
[   93.196760] wlan0: authenticated
[   93.196765] wlan0: associate with AP 00:23:f8:21:d7:f6
[   93.204041] wlan0: RX AssocResp from 00:23:f8:21:d7:f6 (capab=0x451 status=0 aid=1)
[   93.204048] wlan0: associated
[   93.213675] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   96.651208] padlock: VIA PadLock not detected.
comm: file 2 is not in sorted order
[  104.072099] wlan0: no IPv6 routers present
[  715.170629] CE: hpet increasing min_delta_ns to 33750 nsec
[38866.638690] SGI XFS with ACLs, security attributes, realtime, large block/inode numbers, no debug enabled
[38866.641922] SGI XFS Quota Management subsystem
[38866.652689] JFS: nTxBlock = 8192, nTxLock = 65536
[38866.688836] NTFS driver 2.1.29 [Flags: R/O MODULE].
[38866.732283] QNX4 filesystem 0.2.3 registered.
[85975.637170] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[85975.637176] vboxdrv: Warning: 2.6.31+ kernel detected. Most likely the hwardware performance
[85975.637179] vboxdrv: counter framework which can generate NMIs is active. You have to prevent
[85975.637182] vboxdrv: the usage of hardware performance counters by
[85975.637184] vboxdrv:   echo 2 > /proc/sys/kernel/perf_counter_paranoid
[85975.637191] vboxdrv: Found 2 processor cores.
[85975.637297] vboxdrv: fAsync=1 offMin=0xbfabc6df offMax=0xbfabc6df
[85975.637384] vboxdrv: TSC mode is 'asynchronous', kernel timer mode is 'normal'.
[85975.637388] vboxdrv: Successfully loaded version 3.0.6_OSE (interface 0x000e0000).
[86251.611678] warning: `VirtualBox' uses 32-bit capabilities (legacy support in use)
[86495.265119] UDF-fs: No VRS found
[86495.265127] UDF-fs: No partition found (1)
[86495.309656] ISO 9660 Extensions: Microsoft Joliet Level 3
[86495.346078] ISO 9660 Extensions: RRIP_1991A