[  112.546684] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[  123.384043] eth1: no IPv6 routers present
[  386.345695] audit_printk_skb: 36 callbacks suppressed
[  386.345703] type=1400 audit(1374128480.826:24): apparmor="STATUS" operation="profile_replace" name="/usr/lib/lightdm/lightdm/lightdm-guest-session-wrapper" pid=4504 comm="apparmor_parser"
[  386.346428] type=1400 audit(1374128480.826:25): apparmor="STATUS" operation="profile_load" name="/usr/lib/lightdm/lightdm/lightdm-guest-session-wrapper//chromium_browser" pid=4504 comm="apparmor_parser"
[  429.283680] SGI XFS with ACLs, security attributes, realtime, large block/inode numbers, no debug enabled
[  429.299596] SGI XFS Quota Management subsystem
[  429.346251] JFS: nTxBlock = 3706, nTxLock = 29648
[  429.437619] NTFS driver 2.1.30 [Flags: R/O MODULE].
[  429.508897] QNX4 filesystem 0.2.3 registered.
[  429.665325] Btrfs loaded
[ 1619.672256] usb 1-2: new high-speed USB device number 2 using ehci_hcd
[ 1619.975440] Initializing USB Mass Storage driver...
[ 1619.975653] scsi2 : usb-storage 1-2:1.0
[ 1619.975831] usbcore: registered new interface driver usb-storage
[ 1619.975836] USB Mass Storage support registered.
[ 1620.974621] scsi 2:0:0:0: Direct-Access     USB1104  Flash Disk       8.00 PQ: 0 ANSI: 2
[ 1620.981147] sd 2:0:0:0: Attached scsi generic sg2 type 0
[ 1620.982198] sd 2:0:0:0: [sdb] 1976320 512-byte logical blocks: (1.01 GB/965 MiB)
[ 1620.982688] sd 2:0:0:0: [sdb] Write Protect is off
[ 1620.982694] sd 2:0:0:0: [sdb] Mode Sense: 03 00 00 00
[ 1620.983188] sd 2:0:0:0: [sdb] No Caching mode page present
[ 1620.983194] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 1620.987331] sd 2:0:0:0: [sdb] No Caching mode page present
[ 1620.987339] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 1621.615551]  sdb: sdb1
[ 1621.620247] sd 2:0:0:0: [sdb] No Caching mode page present
[ 1621.620257] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 1621.620263] sd 2:0:0:0: [sdb] Attached SCSI removable disk
[ 1879.168397] sdb: detected capacity change from 1011875840 to 0
[ 1883.765355] usb 1-2: USB disconnect, device number 2
[ 3811.045139] 8139too 0000:02:00.0: eth1: link down
[ 3815.066219] ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 3821.595938] 8139too 0000:02:00.0: eth1: link up, 100Mbps, full-duplex, lpa 0x45E1
[ 3821.596049] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[ 3822.385795] 8139too 0000:02:00.0: eth1: link down
[ 3823.913279] 8139too 0000:02:00.0: eth1: link up, 100Mbps, full-duplex, lpa 0x45E1
[ 3830.905205] 8139too 0000:02:00.0: eth1: link down
[ 3832.512238] eth1: no IPv6 routers present
[ 3835.022307] ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 3843.959693] 8139too 0000:02:00.0: eth1: link up, 100Mbps, full-duplex, lpa 0x45E1
[ 3843.959778] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[ 3854.248237] eth1: no IPv6 routers present
[ 5331.924051] usb 1-1: new high-speed USB device number 3 using ehci_hcd
[ 5332.062736] scsi3 : usb-storage 1-1:1.2
[ 5332.131734] usblp0: USB Bidirectional printer dev 3 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1723
[ 5332.133576] usbcore: registered new interface driver usblp
[ 5333.062296] scsi 3:0:0:0: Direct-Access     Canon    MP470 series     1030 PQ: 0 ANSI: 2
[ 5333.069089] sd 3:0:0:0: Attached scsi generic sg2 type 0
[ 5333.076559] sd 3:0:0:0: [sdb] Attached SCSI removable disk
[ 5934.341517] usblp0: removed
[ 6041.195636] usblp0: USB Bidirectional printer dev 3 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1723
[12521.958011] usblp0: removed
[12547.934623] usblp0: USB Bidirectional printer dev 3 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1723
[14775.806625] usb 1-1: USB disconnect, device number 3
[14775.809402] usblp0: removed
[14784.612255] usb 1-1: new high-speed USB device number 4 using ehci_hcd
[14784.750237] usblp0: USB Bidirectional printer dev 4 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1723
[14784.753094] scsi4 : usb-storage 1-1:1.2
[14785.754301] scsi 4:0:0:0: Direct-Access     Canon    MP470 series     1030 PQ: 0 ANSI: 2
[14785.760608] sd 4:0:0:0: Attached scsi generic sg2 type 0
[14785.767799] sd 4:0:0:0: [sdb] Attached SCSI removable disk
[16139.815632] usblp0: removed
[16203.161226] usblp0: USB Bidirectional printer dev 4 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1723
[16338.313357] usb 1-1: USB disconnect, device number 4
[16338.315816] usblp0: removed
[16346.884050] usb 1-1: new high-speed USB device number 5 using ehci_hcd
[16347.022459] usblp0: USB Bidirectional printer dev 5 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1723
[16347.025055] scsi5 : usb-storage 1-1:1.2
[16348.026499] scsi 5:0:0:0: Direct-Access     Canon    MP470 series     1030 PQ: 0 ANSI: 2
[16348.033092] sd 5:0:0:0: Attached scsi generic sg2 type 0
[16348.039555] sd 5:0:0:0: [sdb] Attached SCSI removable disk