[ 79.301026] ip_tables: (C) 2000-2006 Netfilter Core Team [ 79.628441] nf_conntrack version 0.5.0 (16384 buckets, 65536 max) [ 86.913374] ADDRCONF(NETDEV_UP): virbr0: link is not ready [ 87.452253] [drm] Changing LVDS panel from (-hsync, -vsync) to (-hsync, +vsync) [ 88.224021] lxcbr0: no IPv6 routers present [ 89.728104] Ebtables v2.0 registered [ 90.781390] ip6_tables: (C) 2000-2006 Netfilter Core Team [ 113.558144] cfg80211: Found new beacon on frequency: 2472 MHz (Ch 13) on phy0 [ 127.988103] init: plymouth-stop pre-start process (2878) terminated with status 1 [ 153.417407] cfg80211: Found new beacon on frequency: 2467 MHz (Ch 12) on phy0 [ 155.556231] [drm] Changing LVDS panel from (-hsync, +vsync) to (-hsync, -vsync) [ 170.076341] wlan0: authenticate with 00:1a:a2:fa:89:61 (try 1) [ 170.079215] wlan0: authenticated [ 170.083509] wlan0: associate with 00:1a:a2:fa:89:61 (try 1) [ 170.095955] wlan0: RX AssocResp from 00:1a:a2:fa:89:61 (capab=0x431 status=0 aid=145) [ 170.095959] wlan0: associated [ 170.103850] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 180.416026] wlan0: no IPv6 routers present [ 276.424144] usb 3-1: USB disconnect, device number 2 [ 280.048102] usb 1-1: new high-speed USB device number 5 using ehci_hcd [ 280.936504] usbcore: registered new interface driver uas [ 280.964988] Initializing USB Mass Storage driver... [ 280.965136] scsi6 : usb-storage 1-1:1.0 [ 280.965218] usbcore: registered new interface driver usb-storage [ 280.965221] USB Mass Storage support registered. [ 281.965679] scsi 6:0:0:0: Direct-Access Lexar JD FireFly 1100 PQ: 0 ANSI: 0 CCS [ 281.966583] sd 6:0:0:0: Attached scsi generic sg1 type 0 [ 281.969515] sd 6:0:0:0: [sdb] 7831552 512-byte logical blocks: (4.00 GB/3.73 GiB) [ 281.970830] sd 6:0:0:0: [sdb] Write Protect is off [ 281.970834] sd 6:0:0:0: [sdb] Mode Sense: 43 00 00 00 [ 281.971885] sd 6:0:0:0: [sdb] No Caching mode page present [ 281.971889] sd 6:0:0:0: [sdb] Assuming drive cache: write through [ 281.975631] sd 6:0:0:0: [sdb] No Caching mode page present [ 281.975635] sd 6:0:0:0: [sdb] Assuming drive cache: write through [ 281.976649] sdb: sdb1 [ 281.978748] sd 6:0:0:0: [sdb] No Caching mode page present [ 281.978751] sd 6:0:0:0: [sdb] Assuming drive cache: write through [ 281.978754] sd 6:0:0:0: [sdb] Attached SCSI removable disk [ 294.381612] EXT4-fs (dm-0): warning: maximal mount count reached, running e2fsck is recommended [ 294.385199] EXT4-fs (dm-0): mounted filesystem with ordered data mode. Opts: (null) [ 330.846537] cfg80211: All devices are disconnected, going to restore regulatory settings [ 330.846543] cfg80211: Restoring regulatory settings [ 330.846916] cfg80211: Calling CRDA to update world regulatory domain [ 330.851060] cfg80211: Ignoring regulatory request Set by core since the driver uses its own custom regulatory domain [ 330.851064] cfg80211: World regulatory domain updated: [ 330.851065] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 330.851068] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 330.851071] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 330.851073] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 330.851075] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 330.851078] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 331.137290] sdb: detected capacity change from 4009754624 to 0 [ 334.020639] usb 1-1: USB disconnect, device number 5 [ 334.134608] wlan0: authenticate with 00:1a:a2:fa:89:61 (try 1) [ 334.142588] wlan0: authenticated [ 334.144557] wlan0: associate with 00:1a:a2:fa:89:61 (try 1) [ 334.147013] wlan0: RX ReassocResp from 00:1a:a2:fa:89:61 (capab=0x431 status=0 aid=149) [ 334.147017] wlan0: associated [ 342.180100] usb 3-1: new low-speed USB device number 3 using uhci_hcd [ 342.373373] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:1a.0/usb3/3-1/3-1:1.0/input/input14 [ 342.373580] generic-usb 0003:046D:C058.0004: input,hidraw0: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:1a.0-1/input0