[   28.355590]   alloc irq_desc for 29 on node -1
[   28.355594]   alloc kstat_irqs on node -1
[   28.355611] tg3 0000:02:00.0: irq 29 for MSI/MSI-X
[   28.380990] ppdev: user-space parallel port driver
[   29.125050] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   29.168299] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   30.730032] tg3: eth0: Link is up at 100 Mbps, full duplex.
[   30.730036] tg3: eth0: Flow control is off for TX and off for RX.
[   30.730216] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   40.912038] eth0: no IPv6 routers present
[ 2267.144057] CE: hpet increasing min_delta_ns to 15000 nsec
[ 6344.055909] CPU1: Temperature above threshold, cpu clock throttled (total events = 1)
[ 6344.055921] Disabling lock debugging due to kernel taint
[ 6344.056685] CPU1: Temperature/speed normal
[ 6599.989043] Machine check events logged
[ 6842.264055] CE: hpet increasing min_delta_ns to 22500 nsec
[10324.388087] usb 2-1: new high speed USB device using ehci_hcd and address 3
[10324.522942] usb 2-1: configuration #1 chosen from 1 choice
[10324.753357] usblp0: USB Bidirectional printer dev 3 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1732
[10324.753813] usbcore: registered new interface driver usblp
[10326.069574] usb 2-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[10361.718591] __ratelimit: 6 callbacks suppressed
[10361.718597] soffice.bin[6133]: segfault at 63d45e9 ip 063d45e9 sp b3d871a0 error 4 in libgcrypt.so.11.5.2[64c3000+70000]
[10421.329702] usb 2-1: USB disconnect, address 3
[10421.330122] usblp0: removed