[   11.834257] udev: starting version 147
[   11.893359] tg3: eth0: Link is up at 100 Mbps, full duplex.
[   11.893361] tg3: eth0: Flow control is off for TX and off for RX.
[   11.893513] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   13.750687] usb 2-4: new high speed USB device using ehci_hcd and address 5
[   13.894436] usb 2-4: configuration #1 chosen from 1 choice
[   16.388202] usb 2-4: reset high speed USB device using ehci_hcd and address 5
[   17.128080] cfg80211: Calling CRDA to update world regulatory domain
[   17.144909] ip_tables: (C) 2000-2006 Netfilter Core Team
[   17.276614] usb 2-4: USB disconnect, address 5
[   17.474759] cfg80211: World regulatory domain updated:
[   17.474762] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   17.474764] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   17.474766] 	(2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   17.474768] 	(2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   17.474770] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   17.474772] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   18.144806] dcdbas dcdbas: Dell Systems Management Base Driver (version 5.6.0-3.2)
[   18.301963] lp: driver loaded but no devices found
[   18.313562] nvidia: module license 'NVIDIA' taints kernel.
[   18.313566] Disabling lock debugging due to kernel taint
[   18.414550] Bluetooth: Generic Bluetooth USB driver ver 0.5
[   18.414648] usbcore: registered new interface driver btusb
[   18.472721] yenta_cardbus 0000:03:01.0: CardBus bridge found [1028:01fe]
[   18.472746] yenta_cardbus 0000:03:01.0: O2: res at 0x94/0xD4: 00/ea
[   18.472748] yenta_cardbus 0000:03:01.0: O2: enabling read prefetch/write burst
[   18.568238] nvidia 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   18.568247] nvidia 0000:01:00.0: setting latency timer to 64
[   18.568383] NVRM: loading NVIDIA UNIX x86 Kernel Module  185.18.36  Fri Aug 14 17:18:04 PDT 2009
[   18.602057] Initializing USB Mass Storage driver...
[   18.602116] usbcore: registered new interface driver usb-storage
[   18.602119] USB Mass Storage support registered.
[   18.602640] input: Dell WMI hotkeys as /devices/virtual/input/input7
[   18.604027] yenta_cardbus 0000:03:01.0: ISA IRQ mask 0x0cb8, PCI irq 19
[   18.604031] yenta_cardbus 0000:03:01.0: Socket status: 30000006
[   18.604034] pci_bus 0000:03: Raising subordinate bus# of parent bus (#03) from #04 to #07
[   18.604041] yenta_cardbus 0000:03:01.0: pcmcia: parent PCI bridge I/O window: 0x2000 - 0x2fff
[   18.604043] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x2000-0x2fff: clean.
[   18.604198] yenta_cardbus 0000:03:01.0: pcmcia: parent PCI bridge Memory window: 0xf9a00000 - 0xf9afffff
[   18.604200] yenta_cardbus 0000:03:01.0: pcmcia: parent PCI bridge Memory window: 0x80000000 - 0x83ffffff
[   18.637216] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for Linux, 1.2.26ks
[   18.637219] iwl3945: Copyright(c) 2003-2009 Intel Corporation
[   18.637333] iwl3945 0000:0c:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[   18.637347] iwl3945 0000:0c:00.0: setting latency timer to 64
[   18.711238] iwl3945 0000:0c:00.0: Tunable channels: 13 802.11bg, 23 802.11a channels
[   18.711241] iwl3945 0000:0c:00.0: Detected Intel Wireless WiFi Link 3945ABG
[   18.711356]   alloc irq_desc for 30 on node -1
[   18.711357]   alloc kstat_irqs on node -1
[   18.711389] iwl3945 0000:0c:00.0: irq 30 for MSI/MSI-X
[   18.996608] phy0: Selected rate control algorithm 'iwl-3945-rs'
[   18.997120] input: DualPoint Stick as /devices/platform/i8042/serio1/input/input8
[   19.020949] input: AlpsPS/2 ALPS DualPoint TouchPad as /devices/platform/i8042/serio1/input/input9
[   19.133124] iwl3945 0000:0c:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   19.310534] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   19.310538] vboxdrv: Warning: 2.6.31+ kernel detected. Most likely the hwardware performance
[   19.310539] vboxdrv: counter framework which can generate NMIs is active. You have to prevent
[   19.310540] vboxdrv: the usage of hardware performance counters by
[   19.310541] vboxdrv:   echo 2 > /proc/sys/kernel/perf_counter_paranoid
[   19.310544] vboxdrv: Found 2 processor cores.
[   19.310611] vboxdrv: fAsync=0 offMin=0x18c offMax=0xee8
[   19.310655] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   19.310656] vboxdrv: Successfully loaded version 3.0.12 (interface 0x00110000).
[   19.466902] iwl3945 0000:0c:00.0: loaded firmware version 15.32.2.9
[   19.475474] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x100-0x3af: clean.
[   19.479217] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: clean.
[   19.480066] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff: clean.
[   19.480758] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7: clean.
[   19.481440] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean.
[   19.539303] Registered led device: iwl-phy0::radio
[   19.539321] Registered led device: iwl-phy0::assoc
[   19.539338] Registered led device: iwl-phy0::RX
[   19.539352] Registered led device: iwl-phy0::TX
[   19.570077] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   19.665794] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   19.665797] Bluetooth: BNEP filters: protocol multicast
[   19.687093] Bridge firewalling registered
[   20.303062] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 21 (level, low) -> IRQ 21
[   20.303086] HDA Intel 0000:00:1b.0: setting latency timer to 64
[   20.371489] input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:1b.0/input/input10
[   20.420628] input: HDA Intel Mic at Ext Left Jack as /devices/pci0000:00/0000:00:1b.0/sound/card0/input11
[   20.420687] input: HDA Intel HP Out at Ext Left Jack as /devices/pci0000:00/0000:00:1b.0/sound/card0/input12
[   21.952036] eth0: no IPv6 routers present
[   22.513274] ppdev: user-space parallel port driver
[   23.085061] usb 2-4: new high speed USB device using ehci_hcd and address 6
[   23.227388] usb 2-4: configuration #1 chosen from 1 choice
[   23.229429] scsi4 : SCSI emulation for USB Mass Storage devices
[   23.229518] usb-storage: device found at 6
[   23.229519] usb-storage: waiting for device to settle before scanning
[   23.236422] usbcore: registered new interface driver usbserial
[   23.236434] USB Serial support registered for generic
[   23.236488] usbcore: registered new interface driver usbserial_generic
[   23.236490] usbserial: USB Serial Driver core
[   23.238597] USB Serial support registered for GSM modem (1-port)
[   23.238645] option 2-4:1.0: GSM modem (1-port) converter detected
[   23.238707] usb 2-4: GSM modem (1-port) converter now attached to ttyUSB0
[   23.238720] option 2-4:1.1: GSM modem (1-port) converter detected
[   23.238756] usb 2-4: GSM modem (1-port) converter now attached to ttyUSB1
[   23.238769] option 2-4:1.2: GSM modem (1-port) converter detected
[   23.238807] usb 2-4: GSM modem (1-port) converter now attached to ttyUSB2
[   23.238820] option 2-4:1.3: GSM modem (1-port) converter detected
[   23.238879] usb 2-4: GSM modem (1-port) converter now attached to ttyUSB3
[   23.238892] option 2-4:1.4: GSM modem (1-port) converter detected
[   23.238944] usb 2-4: GSM modem (1-port) converter now attached to ttyUSB4
[   23.238957] usbcore: registered new interface driver option
[   23.238959] option: v0.7.2:USB Driver for GSM modems
[   28.329324] usb-storage: device scan complete
[   28.332572] scsi 4:0:0:0: Direct-Access     ZTE      MMC Storage      2.31 PQ: 0 ANSI: 2
[   28.332884] sd 4:0:0:0: Attached scsi generic sg2 type 0
[   28.409305] sd 4:0:0:0: [sdb] Attached SCSI removable disk
[  346.998496] cfg80211: Found new beacon on frequency: 5180 MHz (Ch 36) on phy0
[ 1118.436069] CE: hpet increasing min_delta_ns to 15000 nsec
[ 4165.136066] CE: hpet increasing min_delta_ns to 22500 nsec
[ 4501.865416] PPP BSD Compression module registered
[ 4501.883783] PPP Deflate Compression module registered
[ 4502.551444] tg3: eth0: Link is down.
[ 4505.370376] dell-wmi: Unknown key e044 pressed
[ 4927.382893] dell-wmi: Unknown key e043 pressed
[ 4927.625696] tg3: eth0: Link is up at 100 Mbps, full duplex.
[ 4927.625705] tg3: eth0: Flow control is off for TX and off for RX.
[ 5027.115529] cfg80211: Found new beacon on frequency: 5200 MHz (Ch 40) on phy0
[ 5367.146352] NVRM: Xid (0001:00): 13, 0003 00000000 00008297 00001408 00000001 00000040
[ 5367.148086] NVRM: Xid (0001:00): 13, 0003 00000000 00008297 00001408 00000001 00000040
[ 5367.216258] NVRM: Xid (0001:00): 13, 0003 00000000 00008297 00001408 00000001 00000040
[ 5881.032011] hda-intel: azx_get_response timeout, switching to polling mode: last cmd=0x022f0c00
[12567.453183] tg3: eth0: Link is down.
[12570.321347] dell-wmi: Unknown key e044 pressed
[13566.544598] dell-wmi: Unknown key e043 pressed
[13566.595582] tg3: eth0: Link is up at 100 Mbps, full duplex.
[13566.595590] tg3: eth0: Flow control is off for TX and off for RX.
[17939.873869] compiz.real[6044]: segfault at 8 ip 019942c5 sp bfa432e4 error 4 in libGLcore.so.185.18.36[f49000+d6f000]