Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [ 20.150163] iwlagn 0000:0c:00.0: firmware: requesting iwlwifi-5000-2.ucode [ 20.299244] iwlagn 0000:0c:00.0: loaded firmware version 8.24.2.12 [ 20.486104] Registered led device: iwl-phy0::radio [ 20.486157] Registered led device: iwl-phy0::assoc [ 20.486208] Registered led device: iwl-phy0::RX [ 20.501609] Registered led device: iwl-phy0::TX [ 20.520749] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 20.559538] tg3 0000:09:00.0: PME# disabled [ 20.559637] alloc irq_desc for 31 on node -1 [ 20.559639] alloc kstat_irqs on node -1 [ 20.559655] tg3 0000:09:00.0: irq 31 for MSI/MSI-X [ 20.619825] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 21.466738] ppdev: user-space parallel port driver comm: file 2 is not in sorted order [ 1888.744744] wlan0: authenticate with AP 00:23:69:2c:56:78 [ 1888.746703] wlan0: authenticated [ 1888.746710] wlan0: associate with AP 00:23:69:2c:56:78 [ 1888.750070] wlan0: RX AssocResp from 00:23:69:2c:56:78 (capab=0x411 status=0 aid=1) [ 1888.750079] wlan0: associated [ 1888.752024] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 1889.119503] padlock: VIA PadLock not detected. [ 1898.825019] wlan0: no IPv6 routers present [ 1908.541249] process `skype' is using obsolete setsockopt SO_BSDCOMPAT [ 2202.613044] CE: hpet increasing min_delta_ns to 15000 nsec [ 2278.984282] usb 2-2: new high speed USB device using ehci_hcd and address 4 [ 2279.119884] usb 2-2: configuration #1 chosen from 1 choice [ 2279.245992] Initializing USB Mass Storage driver... [ 2279.246152] usbcore: registered new interface driver usb-storage [ 2279.247154] USB Mass Storage support registered. [ 2279.263650] scsi5 : SCSI emulation for USB Mass Storage devices [ 2279.264016] usb-storage: device found at 4 [ 2279.264022] usb-storage: waiting for device to settle before scanning [ 2279.264267] usbcore: registered new interface driver ums-cypress [ 2284.265444] usb-storage: device scan complete [ 2284.273396] scsi 5:0:0:0: Direct-Access SAMSUNG HM120JC 0000 PQ: 0 ANSI: 0 [ 2284.275203] sd 5:0:0:0: Attached scsi generic sg2 type 0 [ 2284.276225] sd 5:0:0:0: [sdb] 234441648 512-byte logical blocks: (120 GB/111 GiB) [ 2284.277121] sd 5:0:0:0: [sdb] Write Protect is off [ 2284.277129] sd 5:0:0:0: [sdb] Mode Sense: 27 00 00 00 [ 2284.277134] sd 5:0:0:0: [sdb] Assuming drive cache: write through [ 2284.286095] sd 5:0:0:0: [sdb] Assuming drive cache: write through [ 2284.286106] sdb: sdb1 [ 2284.746350] sd 5:0:0:0: [sdb] Assuming drive cache: write through [ 2284.746361] sd 5:0:0:0: [sdb] Attached SCSI disk [ 2284.855565] sd 5:0:0:0: [sdb] Sense Key : Recovered Error [current] [descriptor] [ 2284.855581] Descriptor sense data with sense descriptors (in hex): [ 2284.855587] 72 01 00 1d 00 00 00 0e 09 0c 00 00 00 00 00 00 [ 2284.855616] 00 00 00 00 e0 50 [ 2284.855631] sd 5:0:0:0: [sdb] Add. Sense: ATA pass through information available [ 2284.863104] sd 5:0:0:0: [sdb] Sense Key : Recovered Error [current] [descriptor] [ 2284.863120] Descriptor sense data with sense descriptors (in hex): [ 2284.863125] 72 01 00 1d 00 00 00 0e 09 0c 00 00 00 00 00 00 [ 2284.863154] 00 4f 00 c2 e0 50 [ 2284.863168] sd 5:0:0:0: [sdb] Add. Sense: ATA pass through information available [ 2285.014283] sd 5:0:0:0: [sdb] Sense Key : Recovered Error [current] [descriptor] [ 2285.014289] Descriptor sense data with sense descriptors (in hex): [ 2285.014292] 72 01 00 1d 00 00 00 0e 09 0c 00 00 00 00 00 00 [ 2285.014302] 00 00 00 00 e0 50 [ 2285.014307] sd 5:0:0:0: [sdb] Add. Sense: ATA pass through information available [ 2285.029608] sd 5:0:0:0: [sdb] Sense Key : Recovered Error [current] [descriptor] [ 2285.029624] Descriptor sense data with sense descriptors (in hex): [ 2285.029630] 72 01 00 1d 00 00 00 0e 09 0c 00 00 00 00 00 00 [ 2285.029659] 00 4f 00 c2 e0 50 [ 2285.029673] sd 5:0:0:0: [sdb] Add. Sense: ATA pass through information available [ 2285.069579] sd 5:0:0:0: [sdb] Sense Key : Recovered Error [current] [descriptor] [ 2285.069595] Descriptor sense data with sense descriptors (in hex): [ 2285.069601] 72 01 00 1d 00 00 00 0e 09 0c 00 00 00 ff 00 00 [ 2285.069630] 00 00 00 00 e0 50 [ 2285.069644] sd 5:0:0:0: [sdb] Add. Sense: ATA pass through information available [ 2285.157324] sd 5:0:0:0: [sdb] Sense Key : Recovered Error [current] [descriptor] [ 2285.157339] Descriptor sense data with sense descriptors (in hex): [ 2285.157345] 72 01 00 1d 00 00 00 0e 09 0c 00 00 00 00 00 00 [ 2285.157374] 00 4f 00 c2 e0 50 [ 2285.157389] sd 5:0:0:0: [sdb] Add. Sense: ATA pass through information available [ 2285.234572] sd 5:0:0:0: [sdb] Sense Key : Recovered Error [current] [descriptor] [ 2285.234586] Descriptor sense data with sense descriptors (in hex): [ 2285.234592] 72 01 00 1d 00 00 00 0e 09 0c 00 00 00 00 00 00 [ 2285.234620] 00 4f 00 c2 e0 50 [ 2285.234635] sd 5:0:0:0: [sdb] Add. Sense: ATA pass through information available [ 2285.414286] kjournald starting. Commit interval 5 seconds [ 2285.415120] EXT3 FS on sdb1, internal journal [ 2285.415133] EXT3-fs: mounted filesystem with writeback data mode. [ 2318.656084] CE: hpet increasing min_delta_ns to 22500 nsec [ 2669.904782] usb 2-2: USB disconnect, address 4