[ 4.466977] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [ 4.467309] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [ 4.469014] iwlwifi 0000:03:00.0: L1 Enabled; Disabling L0S [ 4.469209] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0 [ 4.847125] [drm] Enabling RC6 states: RC6 on, RC6p off, RC6pp off [ 4.851916] iwlwifi 0000:03:00.0: L1 Enabled; Disabling L0S [ 4.852124] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0 [ 5.049404] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 5.049926] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 6.671891] init: plymouth main process (184) killed by SEGV signal [ 7.611811] psmouse serio2: alps: Unknown ALPS touchpad: E7=10 00 64, EC=10 00 64 [ 11.215411] wlan0: authenticate with bc:05:43:e7:71:fa [ 11.219633] wlan0: send auth to bc:05:43:e7:71:fa (try 1/3) [ 11.258350] wlan0: authenticated [ 11.260507] wlan0: associate with bc:05:43:e7:71:fa (try 1/3) [ 11.261823] wlan0: RX AssocResp from bc:05:43:e7:71:fa (capab=0x411 status=0 aid=1) [ 11.279622] wlan0: associated [ 11.279653] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 11.279704] cfg80211: Calling CRDA for country: DE [ 11.282093] cfg80211: Regulatory domain changed to country: DE [ 11.282096] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 11.282098] cfg80211: (2400000 KHz - 2483500 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 11.282100] cfg80211: (5150000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 11.282101] cfg80211: (5250000 KHz - 5350000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 11.282103] cfg80211: (5470000 KHz - 5725000 KHz @ 40000 KHz), (N/A, 2698 mBm) [ 11.359725] wlan0: Limiting TX power to 23 (23 - 0) dBm as advertised by bc:05:43:e7:71:fa [ 11.579110] psmouse serio2: trackpoint: IBM TrackPoint firmware: 0x0e, buttons: 3/3 [ 11.839267] input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio2/input/input11 [ 13.307662] IPv6: ADDRCONF(NETDEV_UP): wwan0: link is not ready [ 13.307789] IPv6: ADDRCONF(NETDEV_UP): wwan0: link is not ready