[   18.991834] iwlwifi 0000:12:00.0: Radio type=0x0-0x0-0x3
[   19.136011] iwlwifi 0000:12:00.0: L1 Disabled; Enabling L0S
[   19.143376] iwlwifi 0000:12:00.0: Radio type=0x0-0x0-0x3
[   19.292736] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   19.293403] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   19.605764] r8169 0000:16:00.0 eth0: link down
[   19.605822] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   19.606182] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   19.930375] init: udev-fallback-graphics main process (1381) terminated with status 1
[   19.994155] init: plymouth-splash main process (1397) terminated with status 1
[   20.583872] wlan0: authenticate with 00:24:b2:59:f7:dd
[   20.587333] wlan0: capabilities/regulatory prevented using AP HT/VHT configuration, downgraded
[   20.588182] wlan0: send auth to 00:24:b2:59:f7:dd (try 1/3)
[   20.590653] wlan0: authenticated
[   20.590959] iwlwifi 0000:12:00.0 wlan0: disabling HT as WMM/QoS is not supported by the AP
[   20.590962] iwlwifi 0000:12:00.0 wlan0: disabling VHT as WMM/QoS is not supported by the AP
[   20.593470] wlan0: associate with 00:24:b2:59:f7:dd (try 1/3)
[   20.596284] wlan0: RX AssocResp from 00:24:b2:59:f7:dd (capab=0x431 status=0 aid=2)
[   20.599861] wlan0: associated
[   20.599905] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   20.600020] cfg80211: Calling CRDA for country: US
[   20.606591] cfg80211: Regulatory domain changed to country: US
[   20.606598] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   20.606603] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   20.606607] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[   20.606611] cfg80211:   (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   20.606615] cfg80211:   (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   20.606618] cfg80211:   (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   20.606622] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[   20.653552] wlan0: Limiting TX power to 27 (27 - 0) dBm as advertised by 00:24:b2:59:f7:dd
[   22.264436] NVRM: GPU at 0000:02:00: GPU-cb5b87f7-f3df-04ca-7ca9-56399a6196ff
[ 6104.336039] iwlwifi 0000:12:00.0: RF_KILL bit toggled to disable radio.
[ 6104.336143] wlan0: deauthenticating from 00:24:b2:59:f7:dd by local choice (reason=3)
[ 6104.336371] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.336375] wlan0: failed to remove key (0, 00:24:b2:59:f7:dd) from hardware (-5)
[ 6104.339772] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.339786] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.339798] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.339808] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.339815] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.339926] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.339933] wlan0: failed to remove key (1, ff:ff:ff:ff:ff:ff) from hardware (-5)
[ 6104.340124] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.340130] wlan0: failed to remove key (2, ff:ff:ff:ff:ff:ff) from hardware (-5)
[ 6104.340325] cfg80211: Calling CRDA to update world regulatory domain
[ 6104.355894] iwlwifi 0000:12:00.0: Not sending command - RF KILL
[ 6104.357562] cfg80211: World regulatory domain updated:
[ 6104.357566] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 6104.357568] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6104.357570] cfg80211:   (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 6104.357572] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 6104.357574] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6104.357576] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6104.421510] usb 1-1.2: USB disconnect, device number 3
[ 6104.538010] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 6106.704014] iwlwifi 0000:12:00.0: RF_KILL bit toggled to enable radio.
[ 6106.705538] iwlwifi 0000:12:00.0: L1 Disabled; Enabling L0S
[ 6106.713073] iwlwifi 0000:12:00.0: Radio type=0x0-0x0-0x3
[ 6106.897676] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 6106.939036] usb 1-1.2: new full-speed USB device number 5 using ehci-pci
[ 6107.035850] usb 1-1.2: New USB device found, idVendor=0a5c, idProduct=21b2
[ 6107.035859] usb 1-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 6107.035864] usb 1-1.2: Product: BRCM2070 BT 2.1 + HS USB Module
[ 6107.035869] usb 1-1.2: Manufacturer: Broadcom Corp
[ 6107.035873] usb 1-1.2: SerialNumber: 5CAC4CFE8A9F
[ 6107.761009] wlan0: authenticate with 00:24:b2:59:f7:dd
[ 6107.775231] wlan0: capabilities/regulatory prevented using AP HT/VHT configuration, downgraded
[ 6107.776131] wlan0: send auth to 00:24:b2:59:f7:dd (try 1/3)
[ 6107.777954] wlan0: authenticated
[ 6107.778210] iwlwifi 0000:12:00.0 wlan0: disabling HT as WMM/QoS is not supported by the AP
[ 6107.778218] iwlwifi 0000:12:00.0 wlan0: disabling VHT as WMM/QoS is not supported by the AP
[ 6107.778796] wlan0: associate with 00:24:b2:59:f7:dd (try 1/3)
[ 6107.782003] wlan0: RX AssocResp from 00:24:b2:59:f7:dd (capab=0x431 status=0 aid=2)
[ 6107.784931] wlan0: associated
[ 6107.784976] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 6107.785115] cfg80211: Calling CRDA for country: US
[ 6107.792347] cfg80211: Regulatory domain changed to country: US
[ 6107.792354] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 6107.792359] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[ 6107.792363] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[ 6107.792367] cfg80211:   (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6107.792371] cfg80211:   (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6107.792374] cfg80211:   (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6107.792378] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[ 6107.873867] wlan0: Limiting TX power to 27 (27 - 0) dBm as advertised by 00:24:b2:59:f7:dd