[Regression] Filename completion does not work with Verbatim Store'n'Go flash drive.

[Niels Kristian Bech Jensen]

Filename completion (pressing the tab key in a terminal) worked in Dapper with my 1GB Verbatim Store'n'Go flash drive. It does not work in Feisty and Gutsy (tested on several systems). Nothing happens when pressing the tab key. Reading to and writing from the drive works perfectly.

Here is the dmesg output from a fully updated Gutsy system with the flash drive inserted.

[ 2728.648000] usb 7-1: new high speed USB device using ehci_hcd and address 3
[ 2728.784000] usb 7-1: configuration #1 chosen from 1 choice
[ 2728.784000] scsi6 : SCSI emulation for USB Mass Storage devices
[ 2728.784000] usb-storage: device found at 3
[ 2728.784000] usb-storage: waiting for device to settle before scanning
[ 2733.784000] usb-storage: device scan complete
[ 2733.784000] scsi 6:0:0:0: Direct-Access VBTM Store 'n' Go 5.00 PQ: 0 ANSI: 0 CCS
[ 2734.216000] sd 6:0:0:0: [sdb] 2013184 512-byte hardware sectors (1031 MB)
[ 2734.216000] sd 6:0:0:0: [sdb] Write Protect is off
[ 2734.216000] sd 6:0:0:0: [sdb] Mode Sense: 23 00 00 00
[ 2734.216000] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 2734.220000] sd 6:0:0:0: [sdb] 2013184 512-byte hardware sectors (1031 MB)
[ 2734.220000] sd 6:0:0:0: [sdb] Write Protect is off
[ 2734.220000] sd 6:0:0:0: [sdb] Mode Sense: 23 00 00 00
[ 2734.220000] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 2734.220000] sdb: sdb1
[ 2734.220000] sd 6:0:0:0: [sdb] Attached SCSI removable disk
[ 2734.220000] sd 6:0:0:0: Attached scsi generic sg2 type 0
[ 3043.196000] usb 7-1: USB disconnect, address 3

[Mika Fischer (zoop)]

Can you confirm that the path to your USB stick contains spaces? If so then this is most likely a duplicate of #194860.

[Niels Kristian Bech Jensen (nkbjensen)]

No, the path does not contain spaces. It is /media/STORE'N'GO.

[Mika Fischer (zoop)]

OK, then this is a duplicate of #123665.