[ 25.526826] Linux video capture interface: v2.00 [ 25.547039] cfg80211: World regulatory domain updated: [ 25.547049] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 25.547056] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 25.547062] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 25.547068] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 25.547073] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 25.547078] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 25.554466] [fglrx] Maximum main memory to use for locked dma buffers: 3406 MBytes. [ 25.554558] [fglrx] vendor: 1002 device: 9802 count: 1 [ 25.555479] [fglrx] ioport: bar 1, base 0x2000, size: 0x100 [ 25.555508] pci 0000:00:01.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 [ 25.555518] pci 0000:00:01.0: setting latency timer to 64 [ 25.590402] [fglrx] Kernel PAT support is enabled [ 25.590459] [fglrx] module loaded - fglrx 8.84.60 [Mar 24 2011] with 1 minors [ 25.603186] uvcvideo: Found UVC 1.00 device Lenovo EasyCamera (5986:0292) [ 25.606070] input: Lenovo EasyCamera as /devices/pci0000:00/0000:00:13.2/usb2/2-3/2-3:1.0/input/input8 [ 25.607939] usbcore: registered new interface driver uvcvideo [ 25.607949] USB Video Class driver (v1.0.0) [ 25.644064] [fglrx] ATIF platform detected with notification ID: 0x81 [ 25.844359] ath9k 0000:03:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 [ 25.844381] ath9k 0000:03:00.0: setting latency timer to 64 [ 25.961803] ath: EEPROM regdomain: 0x65 [ 25.961810] ath: EEPROM indicates we should expect a direct regpair map [ 25.961817] ath: Country alpha2 being used: 00 [ 25.961820] ath: Regpair used: 0x65 [ 25.961826] cfg80211: Updating information on frequency 2412 MHz for a 20 MHz width channel with regulatory rule: [ 25.961832] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961836] cfg80211: Updating information on frequency 2417 MHz for a 20 MHz width channel with regulatory rule: [ 25.961840] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961844] cfg80211: Updating information on frequency 2422 MHz for a 20 MHz width channel with regulatory rule: [ 25.961848] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961852] cfg80211: Updating information on frequency 2427 MHz for a 20 MHz width channel with regulatory rule: [ 25.961856] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961860] cfg80211: Updating information on frequency 2432 MHz for a 20 MHz width channel with regulatory rule: [ 25.961864] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961868] cfg80211: Updating information on frequency 2437 MHz for a 20 MHz width channel with regulatory rule: [ 25.961872] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961876] cfg80211: Updating information on frequency 2442 MHz for a 20 MHz width channel with regulatory rule: [ 25.961880] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961884] cfg80211: Updating information on frequency 2447 MHz for a 20 MHz width channel with regulatory rule: [ 25.961888] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961892] cfg80211: Updating information on frequency 2452 MHz for a 20 MHz width channel with regulatory rule: [ 25.961896] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961900] cfg80211: Updating information on frequency 2457 MHz for a 20 MHz width channel with regulatory rule: [ 25.961904] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961908] cfg80211: Updating information on frequency 2462 MHz for a 20 MHz width channel with regulatory rule: [ 25.961912] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961915] cfg80211: Updating information on frequency 2467 MHz for a 20 MHz width channel with regulatory rule: [ 25.961920] cfg80211: 2457000 KHz - 2482000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961923] cfg80211: Updating information on frequency 2472 MHz for a 20 MHz width channel with regulatory rule: [ 25.961928] cfg80211: 2457000 KHz - 2482000 KHz @ KHz), (N/A mBi, 2000 mBm) [ 25.961931] cfg80211: Disabling freq 2484 MHz as custom regd has no rule that fits a 20 MHz wide channel [ 25.971994] cfg80211: Ignoring regulatory request Set by core since the driver uses its own custom regulatory domain [ 26.077389] ieee80211 phy0: Selected rate control algorithm 'ath9k_rate_control' [ 26.079362] Registered led device: ath9k-phy0::radio [ 26.079462] Registered led device: ath9k-phy0::assoc [ 26.079549] Registered led device: ath9k-phy0::tx [ 26.079633] Registered led device: ath9k-phy0::rx [ 26.079649] ieee80211 phy0: Atheros AR9285 Rev:2 mem=0xffffc90003420000, irq=18 [ 26.249720] ppdev: user-space parallel port driver [ 27.046803] Intel AES-NI instructions are not detected. [ 27.072206] padlock_aes: VIA PadLock not detected. [ 27.153310] fglrx_pci 0000:00:01.0: irq 44 for MSI/MSI-X [ 27.154735] [fglrx] Firegl kernel thread PID: 1458 [ 27.154950] [fglrx] Firegl kernel thread PID: 1460 [ 27.155110] [fglrx] Firegl kernel thread PID: 1461 [ 27.155369] [fglrx] IRQ 44 Enabled [ 27.176198] padlock_sha: VIA PadLock Hash Engine not detected. [ 27.715761] [fglrx] Gart USWC size:1112 M. [ 27.715768] [fglrx] Gart cacheable size:441 M. [ 27.715778] [fglrx] Reserved FB block: Shared offset:0, size:1000000 [ 27.715783] [fglrx] Reserved FB block: Unshared offset:fc83000, size:37d000 [ 27.715787] [fglrx] Reserved FB block: Unshared offset:17ff4000, size:c000 [ 27.790906] EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro,commit=600 [ 28.358409] CPUFREQ: Per core ondemand sysfs interface is deprecated - ignore_nice_load [ 28.397568] Adding 3777232k swap on /dev/mapper/cryptswap1. Priority:-1 extents:1 across:3777232k [ 29.454149] EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro,commit=600 [ 29.546117] ohci_hcd 0000:00:12.0: PCI INT A disabled [ 29.546414] ehci_hcd 0000:00:12.2: PCI INT B disabled [ 29.546459] ehci_hcd 0000:00:12.2: PME# enabled [ 29.561319] ohci_hcd 0000:00:13.0: PCI INT A disabled [ 32.060544] ehci_hcd 0000:00:13.2: PCI INT B disabled [ 32.060615] ehci_hcd 0000:00:13.2: PME# enabled [ 34.422683] hda-intel: IRQ timing workaround is activated for card #0. Suggest a bigger bdl_pos_adj. [ 34.888393] EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro,commit=600 [ 46.470019] hda-intel: azx_get_response timeout, switching to polling mode: last cmd=0x01970700 [ 47.480013] hda_intel: azx_get_response timeout, switching to single_cmd mode: last cmd=0x01970700 [ 194.619354] atkbd serio0: Unknown key pressed (translated set 2, code 0x8e on isa0060/serio0). [ 194.619367] atkbd serio0: Use 'setkeycodes e00e ' to make it known. [ 194.632154] atkbd serio0: Unknown key released (translated set 2, code 0x8e on isa0060/serio0). [ 194.632164] atkbd serio0: Use 'setkeycodes e00e ' to make it known. [ 230.640907] acer-wmi: Acer Laptop WMI Extras unloaded [ 230.676221] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 233.129047] wlan0: authenticate with 06:1f:3f:f7:d1:1a (try 1) [ 233.134014] wlan0: authenticated [ 233.155476] wlan0: associate with 06:1f:3f:f7:d1:1a (try 1) [ 233.158945] wlan0: RX AssocResp from 06:1f:3f:f7:d1:1a (capab=0x431 status=0 aid=2) [ 233.158959] wlan0: associated [ 233.169862] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 243.570112] wlan0: no IPv6 routers present [ 774.911440] Valid eCryptfs headers not found in file header region or xattr region [ 774.911449] Either the lower file is not in a valid eCryptfs format, or the key could not be retrieved. Plaintext passthrough mode is not enabled; returning -EIO [ 774.930315] Valid eCryptfs headers not found in file header region or xattr region [ 774.930326] Either the lower file is not in a valid eCryptfs format, or the key could not be retrieved. Plaintext passthrough mode is not enabled; returning -EIO