[   19.039643] IR RC5(x) protocol handler initialized
[   19.044368] IR RC6 protocol handler initialized
[   19.053451] IR JVC protocol handler initialized
[   19.064245] IR Sony protocol handler initialized
[   19.096026] lirc_dev: IR Remote Control driver registered, major 249 
[   19.097562] IR LIRC bridge handler initialized
[   19.100728] cx23885 driver version 0.0.2 loaded
[   19.104972] cx23885 0000:02:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   19.105225] CORE cx23885[0]: subsystem: 0070:2211, board: Hauppauge WinTV-HVR1270 [card=18,autodetected]
[   19.255614] tveeprom 0-0050: Hauppauge model 22111, rev C2F5, serial# 6317538
[   19.255618] tveeprom 0-0050: MAC address is 00:0d:fe:60:65:e2
[   19.255621] tveeprom 0-0050: tuner model is NXP 18271C2 (idx 155, type 54)
[   19.255624] tveeprom 0-0050: TV standards NTSC(M) ATSC/DVB Digital (eeprom 0x88)
[   19.255627] tveeprom 0-0050: audio processor is CX23888 (idx 40)
[   19.255630] tveeprom 0-0050: decoder processor is CX23888 (idx 34)
[   19.255632] tveeprom 0-0050: has no radio, has IR receiver, has no IR transmitter
[   19.255635] cx23885[0]: hauppauge eeprom: model=22111
[   19.255638] cx23885_dvb_register() allocating 1 frontend(s)
[   19.261573] cx23885[0]: cx23885 based dvb card
[   19.281314] tda18271 1-0060: creating new instance
[   19.283386] TDA18271HD/C2 detected @ 1-0060
[   19.341250] HDA Intel 0000:00:14.2: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   19.418176] hda_codec: ALC888: BIOS auto-probing.
[   19.431716] input: HDA ATI SB Headphone as /devices/pci0000:00/0000:00:14.2/sound/card0/input6
[   19.449622] rtl8180 0000:04:03.0: PCI INT A -> GSI 21 (level, low) -> IRQ 21
[   19.578209] cfg80211: Updating information on frequency 2412 MHz for a 20 MHz width channel with regulatory rule:
[   19.578214] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578217] cfg80211: Updating information on frequency 2417 MHz for a 20 MHz width channel with regulatory rule:
[   19.578220] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578222] cfg80211: Updating information on frequency 2422 MHz for a 20 MHz width channel with regulatory rule:
[   19.578225] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578227] cfg80211: Updating information on frequency 2427 MHz for a 20 MHz width channel with regulatory rule:
[   19.578230] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578232] cfg80211: Updating information on frequency 2432 MHz for a 20 MHz width channel with regulatory rule:
[   19.578235] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578237] cfg80211: Updating information on frequency 2437 MHz for a 20 MHz width channel with regulatory rule:
[   19.578240] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578242] cfg80211: Updating information on frequency 2442 MHz for a 20 MHz width channel with regulatory rule:
[   19.578245] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578247] cfg80211: Updating information on frequency 2447 MHz for a 20 MHz width channel with regulatory rule:
[   19.578250] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578252] cfg80211: Updating information on frequency 2452 MHz for a 20 MHz width channel with regulatory rule:
[   19.578255] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578257] cfg80211: Updating information on frequency 2457 MHz for a 20 MHz width channel with regulatory rule:
[   19.578260] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578262] cfg80211: Updating information on frequency 2462 MHz for a 20 MHz width channel with regulatory rule:
[   19.578265] cfg80211: 2402000 KHz - 2472000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578267] cfg80211: Updating information on frequency 2467 MHz for a 20 MHz width channel with regulatory rule:
[   19.578270] cfg80211: 2457000 KHz - 2482000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578272] cfg80211: Updating information on frequency 2472 MHz for a 20 MHz width channel with regulatory rule:
[   19.578275] cfg80211: 2457000 KHz - 2482000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.578277] cfg80211: Updating information on frequency 2484 MHz for a 20 MHz width channel with regulatory rule:
[   19.578280] cfg80211: 2474000 KHz - 2494000 KHz @  KHz), (300 mBi, 2000 mBm)
[   19.587179] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[   19.587780] ieee80211 phy0: hwaddr 0013495496ec, RTL8185vD + rtl8225
[   19.610732] DVB: registering new adapter (cx23885[0])
[   19.610739] DVB: registering adapter 0 frontend 0 (LG Electronics LGDT3305 VSB/QAM Frontend)...
[   19.611125] cx23885_dev_checkrevision() Hardware revision = 0xd0
[   19.611134] cx23885[0]/0: found at 0000:02:00.0, rev: 4, irq: 16, latency: 0, mmio: 0xfe800000
[   19.611142] cx23885 0000:02:00.0: setting latency timer to 64
[   19.611241] cx23885 0000:02:00.0: irq 44 for MSI/MSI-X
[   19.708536] nvidia 0000:01:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
[   19.708549] nvidia 0000:01:00.0: setting latency timer to 64
[   19.708555] vgaarb: device changed decodes: PCI:0000:01:00.0,olddecodes=io+mem,decodes=none:owns=io+mem
[   19.709956] NVRM: loading NVIDIA UNIX x86_64 Kernel Module  270.41.06  Mon Apr 18 14:53:56 PDT 2011
[   19.805163] usblp0: USB Bidirectional printer dev 2 if 1 alt 0 proto 2 vid 0x03F0 pid 0x4811
[   19.805256] usbcore: registered new interface driver usblp
[   20.026814] vboxdrv: Found 2 processor cores.
[   20.027709] vboxdrv: fAsync=1 offMin=0xaaacd offMax=0xaaacd
[   20.028464] vboxdrv: TSC mode is 'asynchronous', kernel timer mode is 'normal'.
[   20.028468] vboxdrv: Successfully loaded version 4.0.6 (interface 0x00180000).
[   26.880619] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   26.937366] vesafb: framebuffer at 0xfb000000, mapped to 0xffffc90011980000, using 5120k, total 5120k
[   26.937371] vesafb: mode is 1280x1024x32, linelength=5120, pages=0
[   26.937373] vesafb: scrolling: redraw
[   26.937376] vesafb: Truecolor: size=8:8:8:8, shift=24:16:8:0
[   26.937616] Console: switching to colour frame buffer device 160x64
[   26.964263] fb0: VESA VGA frame buffer device
[   26.986115] ppdev: user-space parallel port driver
[   27.013140] audit_printk_skb: 15 callbacks suppressed
[   27.013144] type=1400 audit(1305433822.934:17): apparmor="STATUS" operation="profile_replace" name="/usr/lib/cups/backend/cups-pdf" pid=1335 comm="apparmor_parser"
[   27.015174] type=1400 audit(1305433822.934:18): apparmor="STATUS" operation="profile_replace" name="/usr/sbin/cupsd" pid=1335 comm="apparmor_parser"
[   27.719183] ioremap error for 0xcffb0000-0xcffb1000, requested 0x10, got 0x0
[   29.551724] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=0
[   29.748068] usb 6-2: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[   31.230040] wlan0: authenticate with 00:23:69:55:a5:a3 (try 1)
[   31.232055] wlan0: authenticated
[   31.350033] wlan0: associate with 00:23:69:55:a5:a3 (try 1)
[   31.352270] wlan0: RX AssocResp from 00:23:69:55:a5:a3 (capab=0x411 status=0 aid=4)
[   31.352275] wlan0: associated
[   31.353196] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   33.046399] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=0
[   41.420015] wlan0: no IPv6 routers present
[   99.228763] Intel AES-NI instructions are not detected.
[   99.271853] padlock_aes: VIA PadLock not detected.
[  119.000995] UDF-fs: Partition marked readonly; forcing readonly mount
[  119.031018] UDF-fs INFO UDF: Mounting volume 'NEVERENDER_NO_WORLD_FOR_TOMORR', timestamp 2009/01/27 18:40 (1e98)