[   15.760696] ppdev: user-space parallel port driver
[   28.517274] wlan0: direct probe to AP 00:26:f2:97:e4:37 (try 1)
[   28.517341] wlan0: deauthenticating from 00:26:f2:97:e4:37 by local choice (reason=3)
[   28.517360] wlan0: direct probe to AP 00:26:f2:97:e4:37 (try 1)
[   28.523226] wlan0: direct probe responded
[   28.523231] wlan0: authenticate with AP 00:26:f2:97:e4:37 (try 1)
[   28.530034] wlan0: authenticated
[   28.530055] wlan0: associate with AP 00:26:f2:97:e4:37 (try 1)
[   28.534438] wlan0: RX AssocResp from 00:26:f2:97:e4:37 (capab=0x431 status=0 aid=1)
[   28.534443] wlan0: associated
[   28.575706] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   28.576582] cfg80211: Calling CRDA for country: US
[   28.584065] cfg80211: Received country IE:
[   28.584068] cfg80211: Regulatory domain: US
[   28.584070] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   28.584072] 	(2402000 KHz - 2477000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm)
[   28.584074] cfg80211: CRDA thinks this should applied:
[   28.584075] cfg80211: Regulatory domain: US
[   28.584076] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   28.584079] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   28.584081] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[   28.584083] 	(5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   28.584085] 	(5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   28.584087] 	(5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   28.584089] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[   28.584090] cfg80211: We intersect both of these and get:
[   28.584091] cfg80211: Regulatory domain: 98
[   28.584092] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   28.584094] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   28.584099] cfg80211: Disabling channel 2467 MHz on phy0 due to Country IE
[   28.584100] cfg80211: Disabling channel 2472 MHz on phy0 due to Country IE
[   28.584102] cfg80211: Disabling channel 2484 MHz on phy0 due to Country IE
[   28.584106] cfg80211: Current regulatory domain updated by AP to: US
[   28.584107] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   28.584110] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   28.811531] Intel AES-NI instructions are not detected.
[   28.824236] padlock: VIA PadLock not detected.
[   38.765062] wlan0: no IPv6 routers present
[   52.530513] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020
[ 2102.567183] ath9k: Failed to stop TX DMA in 100 msec after killing last frame
[ 2102.567200] ath9k: Unable to stop TxDMA. Reset HAL!
[ 3331.027126] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020
[ 6362.539243] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020
[10202.543057] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020
[10352.559727] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020
[10442.577762] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020
[12722.566636] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020
[12872.583282] ath9k: DMA failed to stop in 10 ms AR_CR=0x00000024 AR_DIAG_SW=0x00000020