[   21.498222] Bluetooth: L2CAP ver 2.14
[   21.498228] Bluetooth: L2CAP socket layer initialized
[   21.558813] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   21.558820] Bluetooth: BNEP filters: protocol multicast
[   21.617089] Bridge firewalling registered
[   21.648659] Bluetooth: SCO (Voice Link) ver 0.6
[   21.648665] Bluetooth: SCO socket layer initialized
[   21.978089] Bluetooth: RFCOMM TTY layer initialized
[   21.978101] Bluetooth: RFCOMM socket layer initialized
[   21.978106] Bluetooth: RFCOMM ver 1.11
[ 1060.579210] zd1211rw 1-5:1.0: firmware version 4725
[ 1060.619219] zd1211rw 1-5:1.0: zd1211b chip 0ace:1215 v4810 high 00-21-27 MAXIM_NEW_RF pa0 -7---
[ 1060.621736] cfg80211: Calling CRDA for country: DE
[ 1060.654886] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 1060.674547] cfg80211: Regulatory domain changed to country: DE
[ 1060.674554]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 1060.674561]     (2400000 KHz - 2483500 KHz @ 40000 KHz), (N/A, 2000 mBm)
[ 1060.674566]     (5150000 KHz - 5350000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[ 1060.674571]     (5470000 KHz - 5725000 KHz @ 40000 KHz), (N/A, 2698 mBm)
[ 1060.694305] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 1063.293054] wlan0: authenticate with 00:22:75:f3:d5:50 (try 1)
[ 1063.294791] wlan0: authenticated
[ 1063.294816] wlan0: associate with 00:22:75:f3:d5:50 (try 1)
[ 1063.297176] wlan0: RX AssocResp from 00:22:75:f3:d5:50 (capab=0x1 status=0 aid=1)
[ 1063.297180] wlan0: associated
[ 1063.297627] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 1063.298274] cfg80211: Calling CRDA for country: US
[ 1063.303699] cfg80211: Received country IE:
[ 1063.303707] cfg80211: Regulatory domain: US
[ 1063.303711]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 1063.303717]     (2402000 KHz - 2482000 KHz @ 40000 KHz), (10000 mBi, 1600 mBm)
[ 1063.303721] cfg80211: CRDA thinks this should applied:
[ 1063.303725] cfg80211: Regulatory domain: US
[ 1063.303729]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 1063.303736]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[ 1063.303744]     (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[ 1063.303750]     (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1063.303755]     (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1063.303761]     (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1063.303766]     (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[ 1063.303770] cfg80211: We intersect both of these and get:
[ 1063.303773] cfg80211: Regulatory domain: 98
[ 1063.303777]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 1063.303782]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 1600 mBm)
[ 1063.303792] cfg80211: Disabling channel 2467 MHz on phy0 due to Country IE
[ 1063.303796] cfg80211: Disabling channel 2472 MHz on phy0 due to Country IE
[ 1063.303801] cfg80211: Disabling channel 2484 MHz on phy0 due to Country IE
[ 1063.303808] cfg80211: Current regulatory domain updated by AP to: US
[ 1063.303812]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 1063.303818]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 1600 mBm)
[ 1073.376013] wlan0: no IPv6 routers present
[ 1073.384852] process `skype' is using obsolete setsockopt SO_BSDCOMPAT