[   16.296504] IPv6: ADDRCONF(NETDEV_UP): eth2: link is not ready
[   16.357665] IPv6: ADDRCONF(NETDEV_UP): eth2: link is not ready
[   16.456332] IPv6: ADDRCONF(NETDEV_UP): wlan2: link is not ready
[   16.484907] IPv6: ADDRCONF(NETDEV_UP): wlan2: link is not ready
[   18.554617] fglrx_pci 0000:00:01.0: irq 42 for MSI/MSI-X
[   18.556764] <6>[fglrx] Firegl kernel thread PID: 1542
[   18.557319] <6>[fglrx] Firegl kernel thread PID: 1543
[   18.557576] <6>[fglrx] Firegl kernel thread PID: 1544
[   18.557843] <6>[fglrx] IRQ 42 Enabled
[   18.569041] <6>[fglrx] Reserved FB block: Shared offset:0, size:1000000 
[   18.569051] <6>[fglrx] Reserved FB block: Unshared offset:fbce000, size:426000 
[   18.569058] <6>[fglrx] Reserved FB block: Unshared offset:fff4000, size:c000 
[   18.665513] <6>[fglrx] ATIF platform detected with notification ID: 0x81
[   18.685586] wlan2: authenticate with 00:18:e7:ea:01:4b
[   18.713747] wlan2: send auth to 00:18:e7:ea:01:4b (try 1/3)
[   18.716652] wlan2: authenticated
[   18.721041] wlan2: associate with 00:18:e7:ea:01:4b (try 1/3)
[   18.725507] wlan2: RX AssocResp from 00:18:e7:ea:01:4b (capab=0x431 status=0 aid=7)
[   18.725638] wlan2: associated
[   18.725692] IPv6: ADDRCONF(NETDEV_CHANGE): wlan2: link becomes ready
[   23.158025] init: anacron main process (1389) killed by TERM signal
[ 1505.765323] perf samples too long (2503 > 2500), lowering kernel.perf_event_max_sample_rate to 50000
[ 1594.229723] wlan2: deauthenticating from 00:18:e7:ea:01:4b by local choice (reason=3)
[ 1594.574033] cfg80211: Calling CRDA to update world regulatory domain
[ 1594.590444] cfg80211: World regulatory domain updated:
[ 1594.590460] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 1594.590468] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1594.590475] cfg80211:   (2457000 KHz - 2482000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1594.590481] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 1594.590487] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1594.590493] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1595.385512] init: anacron main process (4062) killed by TERM signal
[ 1597.162888] PM: Syncing filesystems ... done.
[ 1597.186754] PM: Preparing system for mem sleep
[ 1597.187115] Freezing user space processes ... (elapsed 0.001 seconds) done.
[ 1597.189020] Freezing remaining freezable tasks ... (elapsed 0.001 seconds) done.
[ 1597.190450] PM: Entering mem sleep
[ 1597.190789] Suspending console(s) (use no_console_suspend to debug)
[ 1597.191379] sd 0:0:0:0: [sda] Synchronizing SCSI cache
[ 1597.194993] sd 0:0:0:0: [sda] Stopping disk
[ 1597.340412] <6>[fglrx] IRQ 42 Disabled
[ 1597.340602] <6>[fglrx] Preparing suspend fglrx in kernel.
[ 1597.831885] <6>[fglrx] Suspending fglrx in kernel completed.
[ 1597.831888] <6>[fglrx] Power down the ASIC .
[ 1597.832354] PM: suspend of devices complete after 641.066 msecs
[ 1597.832626] PM: late suspend of devices complete after 0.266 msecs
[ 1597.855536] pcieport 0000:00:15.2: System wakeup enabled by ACPI
[ 1597.887376] ehci-pci 0000:00:12.2: System wakeup enabled by ACPI
[ 1597.903280] ohci-pci 0000:00:12.0: System wakeup enabled by ACPI
[ 1597.903379] PM: noirq suspend of devices complete after 70.716 msecs
[ 1597.903420] ACPI: Preparing to enter system sleep state S3
[ 1597.908129] PM: Saving platform NVS memory
[ 1597.915066] Disabling non-boot CPUs ...
[ 1597.916358] Broke affinity for irq 19
[ 1598.019034] smpboot: CPU 1 is now offline
[ 1598.019988] ACPI: Low-level resume complete
[ 1598.020113] PM: Restoring platform NVS memory
[ 1598.031055] microcode: CPU0: new patch_level=0x05000119
[ 1598.031268] Enabling non-boot CPUs ...
[ 1598.031342] smpboot: Booting Node 0 Processor 1 APIC 0x1
[ 1598.041400] Initializing CPU#1
[ 1598.042412] LVT offset 0 assigned for vector 0x400
[ 1598.055265] microcode: CPU1: new patch_level=0x05000119
[ 1598.055276] CPU1 is up
[ 1598.057512] ACPI: Waking up from system sleep state S3
[ 1598.071167] ohci-pci 0000:00:12.0: System wakeup disabled by ACPI
[ 1598.087107] ehci-pci 0000:00:12.2: System wakeup disabled by ACPI
[ 1598.151287] PM: noirq resume of devices complete after 93.014 msecs
[ 1598.151556] PM: early resume of devices complete after 0.160 msecs
[ 1598.155210] snd_hda_intel 0000:00:01.1: irq 40 for MSI/MSI-X
[ 1598.156691] pcieport 0000:00:15.2: System wakeup disabled by ACPI
[ 1598.156853] ath: phy0: ASPM enabled: 0x43
[ 1598.160090] <6>[fglrx] Power up the ASIC
[ 1598.539974] <6>[fglrx] Preparing resume fglrx in kernel.
[ 1598.641358] <6>[fglrx] Resuming fglrx in kernel completed.
[ 1598.641457] <6>[fglrx] IRQ 42 Enabled
[ 1598.647196] ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[ 1598.648738] ata1.00: configured for UDMA/133
[ 1598.663421] sd 0:0:0:0: [sda] Starting disk
[ 1599.488370] PM: resume of devices complete after 1336.234 msecs
[ 1599.488769] PM: Finishing wakeup.
[ 1599.490322] usb 2-1: USB disconnect, device number 2
[ 1599.488772] Restarting tasks ... done.
[ 1599.546729] video LNXVIDEO:00: Restoring backlight state
[ 1599.782369] usb 2-1: new high-speed USB device number 4 using ehci-pci
[ 1600.051823] usb 2-1: New USB device found, idVendor=04f2, idProduct=b209
[ 1600.051840] usb 2-1: New USB device strings: Mfr=3, Product=1, SerialNumber=0
[ 1600.051848] usb 2-1: Product: WebCam
[ 1600.051856] usb 2-1: Manufacturer: Chicony Electronics Co., Ltd.
[ 1600.061346] uvcvideo: Found UVC 1.00 device WebCam (04f2:b209)
[ 1600.064298] input: WebCam as /devices/pci0000:00/0000:00:13.2/usb2/2-1/2-1:1.0/input/input14
[ 1600.175777] usb 2-2: new high-speed USB device number 5 using ehci-pci
[ 1600.322406] usb 2-2: New USB device found, idVendor=0bda, idProduct=0138
[ 1600.322425] usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 1600.322434] usb 2-2: Product: USB2.0-CRW
[ 1600.322442] usb 2-2: Manufacturer: Generic
[ 1600.322450] usb 2-2: SerialNumber: 20090516388200000
[ 1600.333400] ums-realtek 2-2:1.0: USB Mass Storage device detected
[ 1600.375797] scsi2 : usb-storage 2-2:1.0
[ 1600.376261] usb 2-2: USB disconnect, device number 5
[ 1600.465458] init: anacron main process (4502) killed by TERM signal
[ 1601.475304] atl1c 0000:06:00.0: irq 41 for MSI/MSI-X
[ 1601.500715] IPv6: ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 1601.720293] IPv6: ADDRCONF(NETDEV_UP): wlan2: link is not ready
[ 1603.923831] wlan2: authenticate with 00:18:e7:ea:01:4b
[ 1603.944204] wlan2: send auth to 00:18:e7:ea:01:4b (try 1/3)
[ 1603.946235] wlan2: authenticated
[ 1603.957286] wlan2: associate with 00:18:e7:ea:01:4b (try 1/3)
[ 1603.961868] wlan2: RX AssocResp from 00:18:e7:ea:01:4b (capab=0x431 status=0 aid=7)
[ 1603.961989] wlan2: associated
[ 1603.962061] IPv6: ADDRCONF(NETDEV_CHANGE): wlan2: link becomes ready