I can also confirm that the Intrepid-proposed package it's working without
any problem. The load_cycle at my HP 6720s laptop stopped the insane
increase rage when using the battery power.

However I still have concerns about the mechanism used to fix this bug. It
would be possible that ubuntu devs make a wiki page explaining whatever they
did in a clean and simple language? It can also used to explain to regular
people (or at least users not familiar with this problem) what happened and
what's going on since the release of this fix.

On Wed, Jan 7, 2009 at 6:26 PM, Tormod Volden <email address hidden>wrote:

> I can confirm success of the intrepid-proposed package. My
> Load_Cycle_Count / Power_On_Hours was 177 (ca 3 per minute) after 2
> months of use (mostly using Intrepid). I went through the Test Case 1-4,
> 6, 7, 5, 4, 6.
>
> --
> High frequency of load/unload cycles on some hard disks may shorten
> lifetime
> https://bugs.launchpad.net/bugs/59695
> You received this bug notification because you are a direct subscriber
> of the bug.
>
> Status in The Dell Project: Confirmed
> Status in "acpi-support" source package in Ubuntu: Fix Released
> Status in "linux-meta" source package in Ubuntu: New
> Status in "pm-utils" source package in Ubuntu: New
> Status in acpi-support in Ubuntu Hardy: Fix Committed
> Status in linux-meta in Ubuntu Hardy: New
> Status in pm-utils in Ubuntu Hardy: New
> Status in acpi-support in Ubuntu Intrepid: Fix Committed
> Status in linux-meta in Ubuntu Intrepid: New
> Status in pm-utils in Ubuntu Intrepid: New
> Status in "acpi-support" source package in Baltix: New
> Status in "acpi-support" source package in Debian: Fix Released
> Status in "pm-utils" source package in Fedora: Invalid
> Status in "laptop-mode-tools" source package in Mandriva: Confirmed
> Status in Suse Linux: Fix Released
>
> Bug description:
> This is not a support forum.  Please do not use it as such (even though it
> has been used as such already).
>
> You can scan through the bug for links to the Ubuntu forums where many,
> many different questions have been asked, answered, and re-answered.  The
> temporary workaround is just below.
>
> See https://wiki.ubuntu.com/PowerManagement for an overview about what is
> involved and for a remedy.
>
> SRU justification: current behavior may lead to premature disk failure in
> laptops due to excessive unnecessary drive parking.  Fix will disable disk
> cycling by default when on AC power, by correcting an error in the hdparm
> logic of acpi-support.
>
> For jaunty, this issue is addressed in acpi-support 0.115.
>
> TEST CASE:
>
> 1. With acpi-support 0.109 (hardy) or 0.114 (intrepid) installed and
> laptop-mode *not* enabled in either /etc/default/laptop-mode or
> /etc/default/acpi-support, monitor the load cycle count of your hard drive
> by running 'sudo smartctl -a /dev/sda|grep Load_Cycle_Count' over an
> interval of several minutes, and observe that it is incrementing.  (If it
> does not increment, your hard drive's manufacturer defaults are sane and you
> are not affected by this problem.)
> 2. install acpi-support from hardy-proposed or intrepid-proposed
> 3. while connected to AC power, monitor 'sudo smartctl -a /dev/sda|grep
> Load_Cycle_Count' again to confirm that the number is no longer incrementing
> 4. (assuming that the system is a laptop:) disconnect the system from AC
> power, and confirm that the number is incrementing again
> 5. enable laptop mode by setting ENABLE_LAPTOP_MODE=true in
> /etc/default/laptop-mode and running 'sudo /etc/init.d/laptop-mode restart'
> 6. reconnect the system to AC power and confirm that the Load_Cycle_Count
> stops incrementing.
> 7. suspend and resume the system and confirm that the Load_Cycle_Count is
> still not incrementing.
>
> REGRESSION POTENTIAL:
>
> As this patch causes "hdparm -B 128" and "hdparm -B 254" to be invoked
> automatically on systems where it was not being run before, there is some
> risk that this change will have a measurable impact on the disk throughput,
> power consumption, and temperature of some hard drives.  Nevertheless, it is
> believed that these APM power settings are the sensible default settings for
> the vast majority of hard drives and that the current behavior poses a
> significant risk to the longevity of hard drives used in a wide range of
> laptop models, so this update should only be blocked if it results in
> confirmed hardware damage that can be expected to apply to a similar range
> of configurations.
>
> Following is a summary of the issue:
> It is confirmed that some systems are seeing an unusually high number of
> load/unload cycles on their hard disks, as evidenced by smartctl.
>
> It was originally surmised that this was related to laptop-mode being
> enabled, but this especially affects systems where laptop-mode is disabled.
>  In fact, aggressive APM is not a bad idea while a system is not on AC, as
> that system is much more likely to encounter a physical impact.
>
> This is due to disk APM settings that let the heads park or disk spin down
> after an idle period that is shorter than the regular disk access patterns
> of the OS.
>
> Then, the heads are only parked for a very short period of time and almost
> imediately loaded again. Making impact protection much ineffective and
> wearing out the drive.
>
> It can happen when the disk asumes aggressive APM settings (like many
> laptop disks) and the OS does not take care to set the APM settings
> accordingly to its current disk access pattern.
>
> This problem has been confirmed in Ubuntu as well as in other distributions
> and on MacOS X and Windows.
>
> Symptoms of this bug are:
> * Frequent HD clicks  -- more than one per 3 minutes while idle, louder
> than the typical access sounds.  Often more than twice per minute.  On some
> disks, the click is very quiet
> * Rapidly Increasing Load_Cycle_Count as displayed in the final number in
> "sudo smartctl -a /dev/hda | grep Load_Cycle_Count" (where /dev/hda is
> replaced with your own hard disk device)
>
> The problem is only present due to the existence of *all four* of the
> following factors:
> * Hardware is set (default or otherwise) to aggressive power management,
> causing heads to park.  (default behaviour of many drives and often the only
> user available type of power management)
> * Disk is touched often, causing heads to unpark. (default behaviour of
> many distributions)
> * Drives are spec'd to a limited number of these cycles.  (600,000 is the
> most common, although some may be spec'd higher or lower).
> * The OS not setting disk APM variables according to current disk access
> pattern.
>
> Reasonable Limits / Criteria for a fix:
> * There should be fewer than ~15 load cycles per hour, except during heavy
> usage while on battery.
> * This provides a life expectancy of over four years, which is reasonable
> for a hard disk.
>
> Temporary Workaround:
> * Follow the above link.
>
> Some hardware with this issue:
> WD1200VE -- http://www.wdc.com/en/library/portable/2879-001121.pdf -- This
> aggressive parking is a feature of this disk, but that feature relies on
> behaviour that allows for significant amounts of (truly) idle time without
> the disk being touched. Notice the "Load/unload cycles" of 600,000.
>
> Example Load_Cycle_Counts:
> * Thinkpad Z60m/Hitachi HTS541080G9SA00 with well over 7000 load cycles in
> only 100 hours.  That's >70 per hour.
> * Gateway MT6451/Western Digital WD1200VE with 164762 load cycles in 3747
> hours (156 days) of uptime.  That's ~43 per hour -- except that the system
> was patched during the initial third of its life, which puts it at ~63/hour
> since Gutsy was installed (and wasn't patched, as I had done with feisty).
>
> Please see for yourself how often your drive is load cycling:
> smartctl -d ata -a /dev/sda
> (This command is for an SATA drive; you'll need to install the
> smartmontools package first.)
>
> You can get the average per hour by the following division:
> Load_Cycle_Count / Power_On_Hours
>
> Old workaround for 7.10 (not working in 8.04):
> https://bugs.launchpad.net/ubuntu/+source/acpi-support/+bug/59695/comments/14
> A more extensive description of the workaround:
> http://ubuntuforums.org/showthread.php?t=591503
>
> You may need to use '254', or a bit lower, as opposed to '255'.  If HD
> temperature gets high, you may want to set it all the way "down" to 200 or
> so.  ~1 click every 2.5-3 minutes is fine.
> Note:  Some disks are unresponsive to having their APM changed by hdparm,
> and therefore the workaround doesn't work.  It would be a good idea, in such
> cases, to disable APM in the BIOS if possible.
>
> See also http://paul.luon.net/journal/hacking/BrokenHDDs.html for a rather
> dramatic account of the effects the current default values may have.
>
>