[  120.422416] lp: driver loaded but no devices found
[  120.531238] ppdev: user-space parallel port driver
[  137.330124] hda-intel: Invalid position buffer, using LPIB read method instead.
[  137.330169] hda-intel: IRQ timing workaround is activated for card #0. Suggest a bigger bdl_pos_adj.
[  189.769108] wlan0: direct probe to AP 00:23:69:2f:7d:4d (try 1)
[  189.769224] wlan0: deauthenticating from 00:23:69:2f:7d:4d by local choice (reason=3)
[  189.769339] wlan0: direct probe to AP 00:23:69:2f:7d:4d (try 1)
[  189.771669] wlan0: direct probe responded
[  189.771685] wlan0: authenticate with AP 00:23:69:2f:7d:4d (try 1)
[  189.776368] wlan0: authenticated
[  189.776445] wlan0: associate with AP 00:23:69:2f:7d:4d (try 1)
[  189.779323] wlan0: RX AssocResp from 00:23:69:2f:7d:4d (capab=0x411 status=0 aid=2)
[  189.779337] wlan0: associated
[  189.780333] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  200.273039] wlan0: no IPv6 routers present
[  263.816433] wlan0: deauthenticating from 00:23:69:2f:7d:4d by local choice (reason=3)
[  266.156492] PM: Syncing filesystems ... done.
[  266.176284] PM: Preparing system for mem sleep
[  266.176300] Freezing user space processes ... (elapsed 0.00 seconds) done.
[  266.179158] Freezing remaining freezable tasks ... (elapsed 0.00 seconds) done.
[  266.180147] PM: Entering mem sleep
[  266.180179] Suspending console(s) (use no_console_suspend to debug)
[  266.210435] btusb_intr_complete: hci0 urb f6759200 failed to resubmit (1)
[  266.211442] btusb_bulk_complete: hci0 urb f6759c00 failed to resubmit (1)
[  266.212446] btusb_bulk_complete: hci0 urb f6759a00 failed to resubmit (1)
[  266.260314] sd 0:0:0:0: [sda] Synchronizing SCSI cache
[  266.260697] sd 0:0:0:0: [sda] Stopping disk
[  266.766776] PM: suspend of drv:sd dev:0:0:0:0 complete after 506.464 msecs
[  267.219886] PM: suspend of drv:psmouse dev:serio1 complete after 453.011 msecs
[  267.324234] PM: suspend of drv:atkbd dev:serio0 complete after 104.316 msecs
[  267.328339] ath9k 0000:01:00.0: PCI INT A disabled
[  267.344397] ACPI handle has no context!
[  267.344423] atl1c 0000:03:00.0: PCI INT A disabled
[  267.344450] ACPI handle has no context!
[  267.360570] ehci_hcd 0000:00:1d.7: PCI INT D disabled
[  267.360589] uhci_hcd 0000:00:1d.2: PCI INT C disabled
[  267.360603] uhci_hcd 0000:00:1d.1: PCI INT B disabled
[  267.360616] uhci_hcd 0000:00:1d.0: PCI INT A disabled
[  267.464309] HDA Intel 0000:00:1b.0: PCI INT A disabled
[  267.480274] PM: suspend of drv:HDA Intel dev:0000:00:1b.0 complete after 119.622 msecs
[  267.480533] PM: suspend of devices complete after 1300.025 msecs
[  267.480542] PM: suspend devices took 1.300 seconds
[  267.496264] PM: late suspend of devices complete after 15.708 msecs
[  267.496306] ACPI: Preparing to enter system sleep state S3
[  267.576029] Disabling non-boot CPUs ...
[  267.576072] CPU0 attaching NULL sched-domain.
[  267.576083] CPU1 attaching NULL sched-domain.
[  267.640033] CPU0 attaching NULL sched-domain.
[  267.641309] Breaking affinity for irq 1
[  267.641333] Breaking affinity for irq 9
[  267.641360] Breaking affinity for irq 17
[  267.641368] Breaking affinity for irq 18
[  267.744046] CPU 1 is now offline
[  267.744053] SMP alternatives: switching to UP code
[  267.752345] Extended CMOS year: 2000
[  267.752345] Back to C!
[  267.752345] CPU0: Thermal monitoring enabled (TM2)
[  267.752345] Extended CMOS year: 2000
[  267.752345] Enabling non-boot CPUs ...
[  267.752345] SMP alternatives: switching to SMP code
[  267.759558] Booting processor 1 APIC 0x1 ip 0x6000
[  267.751081] Initializing CPU#1
[  267.751081] CPU: L1 I cache: 32K, L1 D cache: 24K
[  267.751081] CPU: L2 cache: 512K
[  267.751081] CPU: Physical Processor ID: 0
[  267.751081] CPU: Processor Core ID: 0
[  267.751081] CPU1: Thermal monitoring enabled (TM2)
[  267.848124] CPU1: Intel(R) Atom(TM) CPU Z520   @ 1.33GHz stepping 02
[  267.848295] CPU0 attaching NULL sched-domain.
[  267.876038] CPU0 attaching sched-domain:
[  267.876048]  domain 0: span 0-1 level SIBLING
[  267.876057]   groups: 0 (cpu_power = 589) 1 (cpu_power = 589)
[  267.876074]   domain 1: span 0-1 level MC
[  267.876082]    groups: 0-1 (cpu_power = 1178)
[  267.876096] CPU1 attaching sched-domain:
[  267.876104]  domain 0: span 0-1 level SIBLING
[  267.876111]   groups: 1 (cpu_power = 589) 0 (cpu_power = 589)
[  267.876128]   domain 1: span 0-1 level MC
[  267.876135]    groups: 0-1 (cpu_power = 1178)
[  267.880040] CPU1 is up
[  267.880252] ACPI: Waking up from system sleep state S3
[  267.936727] HDA Intel 0000:00:1b.0: restoring config space at offset 0x1 (was 0x100006, writing 0x100002)
[  267.936779] pcieport 0000:00:1c.0: restoring config space at offset 0x9 (was 0xfff0, writing 0x80108000)
[  267.936887] uhci_hcd 0000:00:1d.0: restoring config space at offset 0x1 (was 0x5, writing 0x1)
[  267.936929] uhci_hcd 0000:00:1d.1: restoring config space at offset 0x1 (was 0x5, writing 0x1)
[  267.936969] uhci_hcd 0000:00:1d.2: restoring config space at offset 0x1 (was 0x5, writing 0x1)
[  267.937033] ehci_hcd 0000:00:1d.7: restoring config space at offset 0x1 (was 0x100006, writing 0x100002)
[  267.937561] PM: early resume of devices complete after 1.037 msecs
[  268.087613] PM: resume of drv:battery dev:PNP0C0A:00 complete after 149.917 msecs
[  268.269495] PM: resume of drv:thermal dev:LNXTHERM:01 complete after 176.377 msecs
[  268.269540] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 23 (level, low) -> IRQ 23
[  268.269553] HDA Intel 0000:00:1b.0: setting latency timer to 64
[  268.269620] uhci_hcd 0000:00:1d.0: PCI INT A -> GSI 20 (level, low) -> IRQ 20
[  268.269630] uhci_hcd 0000:00:1d.0: setting latency timer to 64
[  268.269657] usb usb2: root hub lost power or was reset
[  268.269684] uhci_hcd 0000:00:1d.1: PCI INT B -> GSI 21 (level, low) -> IRQ 21
[  268.269694] uhci_hcd 0000:00:1d.1: setting latency timer to 64
[  268.269718] usb usb3: root hub lost power or was reset
[  268.269743] uhci_hcd 0000:00:1d.2: PCI INT C -> GSI 18 (level, low) -> IRQ 18
[  268.269752] uhci_hcd 0000:00:1d.2: setting latency timer to 64
[  268.269777] usb usb4: root hub lost power or was reset
[  268.269822] ehci_hcd 0000:00:1d.7: PCI INT D -> GSI 19 (level, low) -> IRQ 19
[  268.269834] ehci_hcd 0000:00:1d.7: setting latency timer to 64
[  268.269883] pata_sch 0000:00:1f.1: setting latency timer to 64
[  268.344296] ath9k 0000:01:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[  268.596258] PM: resume of drv:usb dev:usb1 complete after 251.485 msecs
[  268.844281] PM: resume of drv:usb dev:usb4 complete after 247.954 msecs
[  268.850276] sd 0:0:0:0: [sda] Starting disk
[  270.056636] ata1.00: ACPI cmd ef/03:0c:00:00:00:a0 (SET FEATURES) filtered out
[  270.056647] ata1.00: ACPI cmd ef/03:45:00:00:00:a0 (SET FEATURES) filtered out
[  270.056657] ata1.00: ACPI cmd f5/00:00:00:00:00:00 (SECURITY FREEZE LOCK) filtered out
[  270.081031] ata1.00: configured for UDMA/100
[  270.099298] PM: resume of drv:sd dev:0:0:0:0 complete after 1249.016 msecs
[  270.208292] usb 1-3: reset high speed USB device using ehci_hcd and address 2
[  270.342183] PM: resume of drv:usb dev:1-3 complete after 242.840 msecs
[  270.452300] usb 1-7: reset high speed USB device using ehci_hcd and address 4
[  270.647282] PM: resume of drv:usb dev:1-7 complete after 305.047 msecs
[  270.652157] PM: resume of devices complete after 2714.548 msecs
[  270.652493] PM: resume devices took 2.716 seconds
[  270.652589] PM: Finishing wakeup.
[  270.652594] Restarting tasks ... 
[  270.653807] hub 1-0:1.0: over-current change on port 1
[  270.727914] done.
[  270.756101] hub 1-0:1.0: over-current change on port 2
[  270.860049] hub 1-0:1.0: over-current change on port 3
[  271.207259] usb 4-2: USB disconnect, address 2
[  271.700068] usb 4-2: new full speed USB device using uhci_hcd and address 3
[  272.444923] usb 4-2: configuration #1 chosen from 1 choice
[  272.871197] atl1c 0000:03:00.0: irq 24 for MSI/MSI-X
[  272.873752] ADDRCONF(NETDEV_UP): eth0: link is not ready
[  272.930533] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  279.199414] wlan0: deauthenticating from 00:23:69:2f:7d:4d by local choice (reason=3)
[  279.398685] wlan0: direct probe to AP 00:23:69:2f:7d:4d (try 1)
[  279.596161] wlan0: direct probe to AP 00:23:69:2f:7d:4d (try 2)
[  279.598766] wlan0: direct probe responded
[  279.598790] wlan0: authenticate with AP 00:23:69:2f:7d:4d (try 1)
[  279.600982] wlan0: authenticated
[  279.601096] wlan0: associate with AP 00:23:69:2f:7d:4d (try 1)
[  279.604280] wlan0: RX AssocResp from 00:23:69:2f:7d:4d (capab=0x411 status=0 aid=2)
[  279.604300] wlan0: associated
[  279.605799] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  289.968206] wlan0: no IPv6 routers present