2020-06-14 14:06:59 |
BN |
description |
Hello,
I have 3 HP Proiliant G6 server with 64GB RAM, 16 CPU, 3NIC's, 2 800HD on each server.
Simple setup: Router (10.0.0.0/16, gw 10.0.0.1) - connected to switch - all servers connected to that switch with 2 RJ-45. 2 servers are connected to each other via RJ45 as recommended here https://prnt.sc/szif9k. So I decided to go for AIO Duplex setup where I will have 2 controllers and 1 extended worker node.
Thus, I installed StarlingX 3.0 on USB stick and deployed it on my first controller-machine. All info related to my controller-0 machine: http://paste.openstack.org/show/794743/
Thereafter, I want to deploy starlingx on second controller and as I understood I dont need to run installation on second controller using usb stick again. I can just use PXE to start installation on second controller. Following https://docs.starlingx.io/deploy_install_guides/r3_release/bare_metal/aio_duplex_install_kubernetes.html#install-software-on-controller-1-node I start my second server in Network boot mode as you can see by that screenshot - it cant find boot filename via PXE: https://prnt.sc/sziek5 ; Any suggestions on that please? I can see that network is configured on my first machine therefore, I cant figure out why second machine cannot start deployment via network boot.
Thank you and regards |
Hello,
I have 3 HP Proiliant G6 server with 64GB RAM, 16 CPU, 3NIC's, 2 800HD on each server.
Simple setup: Router (10.0.0.0/16, gw 10.0.0.1) - connected to switch - all servers connected to that switch with 2 RJ-45. 2 servers are connected to each other via RJ45 as recommended here https://prnt.sc/szif9k. So I decided to go for AIO Duplex setup where I will have 2 controllers and 1 extended worker node.
Thus, I installed StarlingX 3.0 on USB stick and deployed it on my first controller-machine. All info related to my controller-0 machine: http://paste.openstack.org/show/794744/
Thereafter, I want to deploy starlingx on second controller and as I understood I dont need to run installation on second controller using usb stick again. I can just use PXE to start installation on second controller. Following https://docs.starlingx.io/deploy_install_guides/r3_release/bare_metal/aio_duplex_install_kubernetes.html#install-software-on-controller-1-node I start my second server in Network boot mode as you can see by that screenshot - it cant find boot filename via PXE: https://prnt.sc/sziek5 ; Any suggestions on that please? I can see that network is configured on my first machine therefore, I cant figure out why second machine cannot start deployment via network boot.
Thank you and regards |
|