[ 24.626593] vboxdrv: Found 1 processor cores. [ 24.628705] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'. [ 24.628710] vboxdrv: Successfully loaded version 3.2.12 (interface 0x00140001). [ 24.748090] Skipping EDID probe due to cached edid [ 25.730143] sky2 0000:09:00.0: eth0: Link is up at 100 Mbps, full duplex, flow control both [ 25.730329] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 26.789584] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=0 [ 27.096081] Skipping EDID probe due to cached edid [ 27.524038] Skipping EDID probe due to cached edid [ 27.940049] Skipping EDID probe due to cached edid [ 28.813426] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=0 [ 29.628106] wlan0: authenticate with 00:07:cb:51:58:ff (try 1) [ 29.631825] wlan0: authenticated [ 29.632462] wlan0: associate with 00:07:cb:51:58:ff (try 1) [ 29.636126] wlan0: RX AssocResp from 00:07:cb:51:58:ff (capab=0x11 status=0 aid=1) [ 29.636131] wlan0: associated [ 29.638095] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 29.684077] Skipping EDID probe due to cached edid [ 34.309134] Skipping EDID probe due to cached edid [ 36.608020] eth0: no IPv6 routers present [ 40.000018] wlan0: no IPv6 routers present [ 107.996219] usb 2-3: new high speed USB device using ehci_hcd and address 3 [ 108.191352] usblp0: USB Bidirectional printer dev 3 if 1 alt 0 proto 2 vid 0x03F0 pid 0x6611 [ 108.192307] usbcore: registered new interface driver usblp [ 108.205030] Initializing USB Mass Storage driver... [ 108.205606] scsi5 : usb-storage 2-3:1.3 [ 108.205783] usbcore: registered new interface driver usb-storage [ 108.205785] USB Mass Storage support registered. [ 109.208638] scsi 5:0:0:0: Direct-Access HP Photosmart C4380 1.00 PQ: 0 ANSI: 5 [ 109.210653] sd 5:0:0:0: Attached scsi generic sg2 type 0 [ 109.219863] sd 5:0:0:0: [sdb] Attached SCSI removable disk [ 109.509943] usb 2-3: usbfs: interface 1 claimed by usblp while 'usb' sets config #1 [ 114.984596] usblp0: removed