Delete only deletes content of a page, not the page itself
Bug #1442596 reported by
Jörg Frings-Fürst
This bug affects 2 people
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
Simple Scan |
Fix Released
|
Medium
|
Unassigned | ||
3.14 |
Fix Released
|
Medium
|
Unassigned | ||
3.16 |
Fix Released
|
Medium
|
Unassigned | ||
simple-scan (Debian) |
Fix Released
|
Unknown
|
|||
simple-scan (Ubuntu) |
Fix Released
|
Medium
|
Unassigned | ||
Utopic |
Fix Released
|
Medium
|
Unassigned | ||
Vivid |
Fix Released
|
Medium
|
Unassigned |
Bug Description
[Impact]
Attempting to delete a page in a two page document replaces deleted page with a blank page leaving two pages.
[Test Case]
1. Open Simple Scan
2. Scan two pages
3. Delete a page
Expected result:
Selected page is deleted and one page remains.
Observed result:
Selected page is replaced with a blank page and two pages remain.
[Regression Potential]
Low. The change in revision 701 caused the blank page adding logic to run after the page was removed not before it. This meant it had an off-by-one error when checking if a blank page should be added.
Changed in simple-scan (Debian): | |
status: | Unknown → Confirmed |
Changed in simple-scan: | |
status: | Triaged → Fix Committed |
description: | updated |
Changed in simple-scan: | |
milestone: | none → 3.17.1 |
Changed in simple-scan (Debian): | |
status: | Confirmed → Fix Released |
Changed in simple-scan: | |
status: | Fix Committed → Fix Released |
To post a comment you must log in.
Confirmed this occurs since 3.14 so there must have been a regression after 3.12.