thanks for your reply. So just to make sure I understand it correctly, at NLO I only have to set the ickkw parameter in the run_card to its value and the corresponding Qcut and njetmax FxFx parameters in the shower_card. Is that right?
For LO+PS I will wait for Valentin's response. But one more question about this: how do I set this option in the run_card? I know that in older versions of MG5 there used to be an ickkw = 1 option in the run_card for the MLM scheme. How should I proceed now?
Hi Olivier,
thanks for your reply. So just to make sure I understand it correctly, at NLO I only have to set the ickkw parameter in the run_card to its value and the corresponding Qcut and njetmax FxFx parameters in the shower_card. Is that right?
For LO+PS I will wait for Valentin's response. But one more question about this: how do I set this option in the run_card? I know that in older versions of MG5 there used to be an ickkw = 1 option in the run_card for the MLM scheme. How should I proceed now?
Thanks very much!
Pablo