I've same problem on Packard Bell EasyNote TH36 and setpci command onto rc.local work's fine. Below some useful information. From dmidecode: Manufacturer: Packard Bell Product Name: EasyNote TH36 Version: V1.02 From lspci: 00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 09) (prog-if 00 [VGA controller]) Subsystem: Acer Incorporated [ALI] Device 0459 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- SERR- [disabled] Capabilities: [90] MSI: Enable+ Count=1/1 Maskable- 64bit- Address: fee0300c Data: 4191 Capabilities: [d0] Power Management version 3 Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- Kernel driver in use: i915 Kernel modules: i915 From sysfs: root@amedeo:~# systool -c backlight -v Class = "backlight" Class Device = "acpi_video0" Class Device path = "/sys/devices/pci0000:00/0000:00:02.0/backlight/acpi_video0" actual_brightness = "9" bl_power = "0" brightness = "9" max_brightness = "9" type = "firmware" uevent = Device = "0000:00:02.0" Device path = "/sys/devices/pci0000:00/0000:00:02.0" boot_vga = "1" broken_parity_status= "0" class = "0x030000" config = 86 80 42 2a 07 04 90 00 09 00 00 03 00 00 80 00 04 00 00 d0 00 00 00 00 0c 00 00 c0 00 00 00 00 f1 50 00 00 00 00 00 00 00 00 00 00 25 10 59 04 00 00 00 00 90 00 00 00 00 00 00 00 0b 01 00 00 00 00 00 00 48 00 00 00 09 00 0a 61 b1 6d 51 1f b9 e1 70 03 19 00 00 00 00 00 00 00 00 00 00 bc 00 00 00 00 00 00 02 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 05 d0 01 00 0c 30 e0 fe 91 41 00 00 00 00 00 00 00 00 00 00 09 00 06 20 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 40 01 00 00 01 00 23 00 00 00 00 00 00 00 00 00 34 00 00 00 00 00 00 00 00 00 00 00 00 80 00 1a 41 20 00 00 0b 19 34 07 00 00 00 00 a0 0f 09 00 18 c0 a8 bb consistent_dma_mask_bits= "36" device = "0x2a42" dma_mask_bits = "36" enable = "1" irq = "44" local_cpulist = "0-1" local_cpus = "00000000,00000003" modalias = "pci:v00008086d00002A42sv00001025sd00000459bc03sc00i00" msi_bus = numa_node = "-1" remove = rescan = reset = resource = "0x00000000d0000000 0x00000000d03fffff 0x0000000000140204 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x00000000c0000000 0x00000000cfffffff 0x000000000014220c 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x00000000000050f0 0x00000000000050f7 0x0000000000040101 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000002 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000 0x0000000000000000" subsystem_device = "0x0459" subsystem_vendor = "0x1025" uevent = "DRIVER=i915 PCI_CLASS=30000 PCI_ID=8086:2A42 PCI_SUBSYS_ID=1025:0459 PCI_SLOT_NAME=0000:00:02.0 MODALIAS=pci:v00008086d00002A42sv00001025sd00000459bc03sc00i00" vendor = "0x8086"