The IGEPV2 display when booting from the SD with build 20110303 stays blank.

Bug #729374 reported by Mounir Bsaibes
6
This bug affects 1 person
Affects Status Importance Assigned to Milestone
Linaro Graphics Miscellany
New
Undecided
Unassigned

Bug Description

When booting from the SD with 20110303 image, the IGEPV2 board does not display anything, the display stays black. However, when the SD is remove, the board boots with Pocky and the display works fine.

summary: - The IGEPV2 display wiht Linaro build 20110303 stays blank when booting
- from the SD
+ The IGEPV2 display when booting from the SD with build 20110303 stays
+ blank.
Revision history for this message
Mounir Bsaibes (mounir-bsaibes) wrote :

The kernel was alip

Revision history for this message
Tom Gall (tom-gall) wrote :

What hardware pack was in use?

Revision history for this message
Tom Gall (tom-gall) wrote :

Is there updated information based on the beta release or a later snapshot?

I checked qatracker.linaro.org for IGEP test data for the beta release, none was entered for ALIP or the Ubuntu Desktop.

Changed in linaro:
status: New → Incomplete
Revision history for this message
Mounir Bsaibes (mounir-bsaibes) wrote :

Tried to reproduce this problem on 20110408 build.
The SD image was created with the following command:
linaro-media-create --rootfs ext3 --mmc /dev/mmcblk0 --binary linaro-natty-alip-tar-20110408-0.tar.gz --hwpack hwpack_linaro-igep_20110408-0_armel.tar.gz --dev igep

The Display appears for very short while (originally, no graphics was showing at all). Then the following error is displayed on the serial screen and the display goes blank.

[ 120.389007] omapdss DISPC error: GFX_FIFO_UNDERFLOW, disabling GFX

Changed in linaro:
status: Incomplete → New
affects: linaro → linaro-graphics-wg
Revision history for this message
Mounir Bsaibes (mounir-bsaibes) wrote :
To post a comment you must log in.
This report contains Public information  
Everyone can see this information.

Other bug subscribers