Check edgecut is properly closed during DRC
Bug #1804443 reported by
Frank Severinsen
This bug affects 1 person
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| KiCad |
Fix Released
|
Wishlist
|
Unassigned | ||
Bug Description
Currently there is a check done in the 3D viewer, but wouldn't it make sense to have the DRC check if the edgecut lines are closed?
IIRC the reason for not allowing footprints to have edgecut in them, was it would be hard for the user to make sure the edgecut was closed between the footprint lines and the userdrawn lines.
Revision history for this message
| Seth Hillbrand (sethh) wrote | #1 |
| Changed in kicad: | |
| milestone: | none → 6.0.0-rc1 |
| importance: | Undecided → Wishlist |
| status: | New → Triaged |
Revision history for this message
| Wayne Stambaugh (stambaughw) wrote | #2 |
Revision history for this message
| Frank Severinsen (shack) wrote | #3 |
Revision history for this message
| Seth Hillbrand (sethh) wrote | #4 |
| Changed in kicad: | |
| milestone: | 6.0.0-rc1 → 5.1.0 |
| status: | Triaged → Fix Committed |
| Changed in kicad: | |
| status: | Fix Committed → Fix Released |
To post a comment you must log in.
That's a really good idea, thanks!