Junction size in EEschema is too small
Bug #1737953 reported by
Nikolai
This bug report is a duplicate of:
Bug #1545422: Wishlist: option to control junction size in Eeschema.
Edit
Remove
This bug affects 2 people
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
KiCad |
Incomplete
|
Undecided
|
Unassigned |
Bug Description
Currently size of Junction mark in EEschema is too small.
It's size is less that 1 mm.
Generally this is not a big problem is you only use digital blueprints. But on paper there is not always obvious if the junction present or not.
Proposed solution:
Make junctions bigger. Personally I believe that 1.6 mm (diameter) junction mark is the best.
Some people may want a bit bigger or a bit smaller junctions.
So, I'd propose to make junction size either a fully customizable option in EEschema, or at least to be able to pick from 3-4 predefined sizes.
To post a comment you must log in.
I has been a while since I printed it but I remember it is quite big.
What page size did you specify in the schematics and on what size paper do you print it?