PNS: bad error message for differential pair
Bug #1542592 reported by
Chris Pavlina
This bug affects 3 people
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| KiCad |
Fix Released
|
Low
|
Jeff Young | ||
Bug Description
In the attached kicad_pcb, attempting to start a new differential pair in the middle of the existing one produces this error:
https:/
Quite a confusing error, given that both nets obvious exist. I'm not sure what the intended error is, though.
This happens in builds spanning about the last week or so at least, on both Linux and OSX.
Marking confirmed, seen by multiple people.
Revision history for this message
| Chris Pavlina (pavlina-chris) wrote | #1 |
Revision history for this message
| Jeff Young (jeyjey) wrote | #2 |
Revision history for this message
| Maciej Suminski (orsonmmz) wrote | #3 |
Revision history for this message
| Maciej Suminski (orsonmmz) wrote | #4 |
| Changed in kicad: | |
| importance: | Undecided → Low |
Revision history for this message
| Jeff Young (jeyjey) wrote | #5 |
Revision history for this message
| KiCad Janitor (kicad-janitor) wrote | #6 |
| Changed in kicad: | |
| status: | Confirmed → Fix Committed |
| assignee: | nobody → Jeff Young (jeyjey) |
| Changed in kicad: | |
| status: | Fix Committed → Fix Released |
To post a comment you must log in.
He he... that .png link now produces a 404 error, which I agree would be confusing for a differential pair routing error. ;)
@Chris, is this still an issue.