Change/remove circle pin when wire is connected successfully
Bug #1458083 reported by
Melroy van den Berg
This bug affects 2 people
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
KiCad |
Fix Released
|
Wishlist
|
Unassigned |
Bug Description
Hi,
I got a nice feature request / nice to have. I think it's a nice feature when the open circle of the pins on a component changes to a closed / filled circle when a wire is successfully connected. Or remove the circle completely.
It will create a lot of clarity in Eeschema. Then you're sure the schematic is correct.
Currently the pin circles remains the same.... Moreover, the power symbols should also contains an 'open' circle when a wire isn't connected I think.
Currently, see attachment below (currently.png) how it look likes a.t.m.
See proposal #1:
http://
See proposal #2:
http://
Kind regards,
Melroy van den Berg
Changed in kicad: | |
status: | New → Fix Committed |
Changed in kicad: | |
status: | Fix Committed → Fix Released |
To post a comment you must log in.
Proposal #3: misc.c4757p. com/pins. png
http://
Highlight the unconnected pin even more, and do not *fully* hide (but make less vibrant) the pin mark when it has been connected.