[    3.732169] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[    3.732457] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[    5.081013] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[    5.081124] e1000e 0000:00:19.0 eth0: 10/100 speed: disabling TSO
[    5.081156] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[    5.293621] current rate 0 is different from the runtime rate 32000
[    5.297996] current rate 0 is different from the runtime rate 32000
[    5.320495] current rate 0 is different from the runtime rate 32000
[    5.324871] current rate 0 is different from the runtime rate 32000
[    5.347118] current rate 0 is different from the runtime rate 32000
[    5.351629] current rate 0 is different from the runtime rate 32000
[    7.335920] init: winbind main process (1695) terminated with status 127
[    7.335946] init: winbind main process ended, respawning
[    7.344807] init: winbind main process (1712) terminated with status 127
[    7.344830] init: winbind main process ended, respawning
[    7.359048] init: winbind main process (1718) terminated with status 127
[    7.359074] init: winbind main process ended, respawning
[    7.370771] init: winbind main process (1722) terminated with status 127
[    7.370796] init: winbind main process ended, respawning
[    7.380615] init: winbind main process (1726) terminated with status 127
[    7.380643] init: winbind main process ended, respawning
[    7.391304] init: winbind main process (1731) terminated with status 127
[    7.391332] init: winbind main process ended, respawning
[    7.398984] init: winbind main process (1735) terminated with status 127
[    7.399009] init: winbind main process ended, respawning
[    7.408354] init: winbind main process (1738) terminated with status 127
[    7.408382] init: winbind main process ended, respawning
[    7.416976] init: winbind main process (1741) terminated with status 127
[    7.417000] init: winbind main process ended, respawning
[    7.425121] init: winbind main process (1744) terminated with status 127
[    7.425146] init: winbind main process ended, respawning
[    7.433994] init: winbind main process (1747) terminated with status 127
[    7.434017] init: winbind respawning too fast, stopped
[  178.500019] usb 2-3: new high-speed USB device number 5 using ehci-pci
[  178.632933] usb 2-3: New USB device found, idVendor=03f0, idProduct=a511
[  178.632938] usb 2-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[  178.632942] usb 2-3: Product: Photosmart 6510 series
[  178.632945] usb 2-3: Manufacturer: HP
[  178.632948] usb 2-3: SerialNumber: CN18J3127G05QB
[  207.042072] WARNING! power/level is deprecated; use power/control instead
[  207.051406] usb-storage 2-3:1.2: USB Mass Storage device detected
[  207.051499] scsi8 : usb-storage 2-3:1.2
[  207.051624] usbcore: registered new interface driver usb-storage
[  207.053689] usblp 2-3:1.1: usblp2: USB Bidirectional printer dev 5 if 1 alt 0 proto 2 vid 0x03F0 pid 0xA511
[  207.053786] usbcore: registered new interface driver usblp
[  208.048596] scsi 8:0:0:0: Direct-Access     HP       Photosmart 6510  1.00 PQ: 0 ANSI: 5
[  208.048884] sd 8:0:0:0: Attached scsi generic sg2 type 0
[  208.051833] sd 8:0:0:0: [sdb] Attached SCSI removable disk
[  224.055333] current rate 0 is different from the runtime rate 32000
[  224.059705] current rate 0 is different from the runtime rate 32000
[  224.082577] current rate 0 is different from the runtime rate 32000
[  224.086957] current rate 0 is different from the runtime rate 32000
[  224.111075] current rate 0 is different from the runtime rate 32000
[  224.115449] current rate 0 is different from the runtime rate 32000
[  461.964878] usblp2: removed
[  461.968123] Did not find alt setting 1 for intf 0, config 1