[   10.614061] ppdev: user-space parallel port driver
[   10.640461] fb0: inteldrmfb frame buffer device
[   10.640469] registered panic notifier
[   10.640486] [drm] Initialized i915 1.6.0 20080730 for 0000:00:02.0 on minor 0
[   10.640618]   alloc irq_desc for 22 on node -1
[   10.640628]   alloc kstat_irqs on node -1
[   10.640652] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22
[   10.640747] HDA Intel 0000:00:1b.0: setting latency timer to 64
[   10.646047] vga16fb: initializing
[   10.646056] vga16fb: mapped to 0xc00a0000
[   10.646203] fb1: VGA16 VGA frame buffer device
[   10.746477] hda_codec: ALC662 rev1: BIOS auto-probing.
[   10.748355] input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:1b.0/input/input6
[   10.811983] Console: switching to colour frame buffer device 128x48
[  433.940040] usb 1-4: new high speed USB device using ehci_hcd and address 5
[  434.212162] usb 1-4: configuration #1 chosen from 1 choice
[  434.262413] cfg80211: Calling CRDA to update world regulatory domain
[  434.275030] cfg80211: World regulatory domain updated:
[  434.275041] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  434.275052] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  434.275061] 	(2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  434.275070] 	(2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  434.275079] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  434.275088] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  434.456067] phy0 -> rt2500usb_init_eeprom: Error - Invalid RT chipset detected.
[  434.456078] phy0 -> rt2x00lib_probe_dev: Error - Failed to allocate device.
[  434.456177] usbcore: registered new interface driver rt2500usb
[  434.748034] phy1: Selected rate control algorithm 'minstrel'
[  434.749776] Registered led device: rt73usb-phy1::radio
[  434.749877] Registered led device: rt73usb-phy1::assoc
[  434.749945] Registered led device: rt73usb-phy1::quality
[  434.750497] usbcore: registered new interface driver rt73usb
[  434.781365] rt73usb 1-4:1.0: firmware: requesting rt73.bin
[  434.889840] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  442.451255] wlan0: deauthenticating from 00:c0:49:ee:0c:32 by local choice (reason=3)
[  442.453452] wlan0: direct probe to AP 00:c0:49:ee:0c:32 (try 1)
[  442.455093] wlan0: direct probe responded
[  442.455102] wlan0: authenticate with AP 00:c0:49:ee:0c:32 (try 1)
[  442.456695] wlan0: authenticated
[  442.456743] wlan0: associate with AP 00:c0:49:ee:0c:32 (try 1)
[  442.459714] wlan0: RX AssocResp from 00:c0:49:ee:0c:32 (capab=0x471 status=0 aid=1)
[  442.459721] wlan0: associated
[  442.473256] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  442.483328] cfg80211: Calling CRDA for country: EU
[  452.600517] wlan0: no IPv6 routers present
[  867.424076] usb 2-2: USB disconnect, address 2
[  870.576541] usb 2-2: new low speed USB device using uhci_hcd and address 3
[  870.749478] usb 2-2: configuration #1 chosen from 1 choice
[  870.794436] input: eGalax Inc. Touch as /devices/pci0000:00/0000:00:1d.0/usb2/2-2/2-2:1.0/input/input7
[  870.796262] generic-usb 0003:0EEF:0001.0003: input,hiddev96,hidraw0: USB HID v1.12 Pointer [eGalax Inc. Touch] on usb-0000:00:1d.0-2/input0