séries Kobo non affectées

[Laurent]

Bonjour,
Je viens de faire la dernière MAJ (4.13) et lors de l'envoie des ebook sur ma Kobo, les Séries ne sont plus mis à jour.

Et donc les livre ne sont plus regroupés lorsque l'on va dans Mes Livres > Séries

Alors que tout fonctionnait bien jusqu'à présent.

Merci d'avance

Calibre v4.13 / Win 10

[Kovid Goyal (kovid)]

Changing the component for this bug.

 assignee davidfor
 tag kobo-driver
 status triaged

[David Forrester (davidfor)]

Google translate gives this as:

I just did the last update (4.13) and when sending ebooks to my Kobo, the Series are no longer updated.

And so the books are no longer grouped when you go to My Books> Series

While everything has worked well so far.

Unless there is an error being shown when the device is connected, the series info should be being updated. The most likely reason it is not, is because the configuration has changed. The most common reasons for this are:

- Changing between the built-in KoboTouch driver and the KoboTouchExtended driver. These are configured separately. You need to configure the one you are currently using.

- In the preferences, on the "Sending books to devices" page, the "Metadata management" option is best set to the automatic option. This will do the update of the metadata when the device is connected.

- Check that the driver is actually configured to update the metadata, including the series.

- If you are using the KoboTouchExtended driver, something can happen that it gets uninstalled. W haven't been able to find a reason for this. But, it means that the built-in KoboTouch driver will be used instead, and that might not be configured in the way you want it to be.

And, the series info is not updated when you send a book to the device. You need to disconnect the device, let it import the book and then connect again. At that point the series info should be updated.

If none of the above solves the problem, I would need to see a debug log. Run calibre in debug mode, connect the device and let the connection jobs run. When they are finished, close calibre and the debug logged should be displayed. Post the full log for me to look at.