Vague error message needs to be more descriptive

[kvdb]

Tried out oregano.

Put a VDC, resistor and capacitor on the schematic. drew some wires between them and added a volt clamp.

Tried to run a simulation. Didn't work. But the error was very clear. I needed a GND too (afterwards, I read that in the help too). Ok, added a GND to the schematic and tried to simulate again.

This time a vague error which doesn't help me:

### Too few or none analysis found ###

A hint would be great. Where do I use/add an analysis?
Or maybe an example diagram inside the /usr/share/doc/oregano directory that would get me started.

It looks really useful, but I'm stuck at this point. Because I used pspice quite a lot at university several years ago, I imagine I'm not the only one being stuck.

Cheers,
Kees

[Barry deFreese (bddebian)]

I am dropping the severity on this to wishlist. This should really be filed upstream. Thank you.

[Dominique Ramaekers (dominique-ramaekers)]

I've just installed oregano in Ubuntu Utopic.

Put in a DC power, a speaker, a test-clamp, and a GND. It seems to work fine.

An example can be found in /usr/share/doc/oregano/examples/

The example doesn't work out of the box dough. A testclamp is needed and a value has to be assigned to the voltage source.

This bug can be closed. I'll open a new one for the faulty example.