ghost interrupt is reported from terminated MMC port on Menlow
Bug #307012 reported by
Owen Kwon
This bug affects 1 person
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| Moblin Kernel |
New
|
Undecided
|
Unassigned | ||
Bug Description
Menlow design guide says that unused CMD and two other pins should be wired and pulled up by one register.(I cannot be more specific because I am not an HW guy) But in this case I got the following message regulary and interupt from MMC controller is generated actually.
mmc0: Got command interrupt 0x00030000 even though no command operation was in progress
This problem is not reproduced if each 3 pins pulled up separately.
To post a comment you must log in.
