Board and fp editors draw graphic circle with wrong line width
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
KiCad |
Fix Released
|
High
|
Seth Hillbrand |
Bug Description
I'm trying to draw a graphic circle. Both fp and board editors create a circle where the the end point marker isn't in the center line of the drawn line. The width of the line is smaller when measured than it should be. A screenshot is attached where the line width should be 1mm (as seen in the bottom of the view). The measured width is 0.65mm and the white marker of the endpoint is in the right place (0.45mm radius) but it's not in the center of the line width.
Application: kicad
Version: (5.1.0-
Libraries:
wxWidgets 3.0.4
libcurl/7.61.1 OpenSSL/1.1.1 (WinSSL) zlib/1.2.11 brotli/1.0.6 libidn2/2.0.5 libpsl/0.20.2 (+libidn2/2.0.5) nghttp2/1.34.0
Platform: Windows 7 (build 7601, Service Pack 1), 64-bit edition, 64 bit, Little endian, wxMSW
Build Info:
wxWidgets: 3.0.4 (wchar_t,wx containers,
Boost: 1.68.0
OpenCASCADE Community Edition: 6.9.1
Curl: 7.61.1
Compiler: GCC 8.2.0 with C++ ABI 1013
Build settings:
USE_
USE_
KICAD_
KICAD_
KICAD_
KICAD_
KICAD_
KICAD_
BUILD_
KICAD_
KICAD_
KICAD_SPICE=ON
Changed in kicad: | |
importance: | Undecided → High |
milestone: | none → 5.1.1 |
Changed in kicad: | |
status: | Fix Committed → Fix Released |
Changed in kicad: | |
status: | Fix Released → Fix Committed |
Changed in kicad: | |
status: | Fix Committed → Fix Released |
This affects also old designs when opened, at least in the fp editor. This is critical because it may generate wrong gerbers, although I haven't tried it yet.