Wishlist: Add option to remove silk from outside the board edges
Bug #1804992 reported by
Rene Poeschl
This bug affects 6 people
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| KiCad |
Fix Released
|
Unknown
|
|||
Bug Description
Sometimes one has a connector overhanging the board edge. In such a case it would be beneficial to be able to remove silk from outside the board. The only way to achieve this now is by designing a special footprint that has no silk in the effected area.
Revision history for this message
| Gabriel Staples (ercaguy) wrote | #1 |
| Changed in kicad: | |
| status: | New → Triaged |
| importance: | Undecided → Wishlist |
Revision history for this message
| Michele Giorato (mr-miky64) wrote | #2 |
Revision history for this message
| KiCad Janitor (kicad-janitor) wrote | #3 |
| Changed in kicad: | |
| status: | Triaged → Expired |
| Changed in kicad: | |
| importance: | Wishlist → Unknown |
| status: | Expired → New |
| Changed in kicad: | |
| status: | New → Fix Released |
To post a comment you must log in.
Motivation: https:/
Note that the purpose here is to allow clean panelization, so it would need to not cross over into adjacent boards if many boards are being panelized with v cuts to be done between them.