initialising-problems with single-pipe Brakes

[Rippstein]

A)
In The Route Europa2 Innsbruck-St.Anton, activity Bride and groom, the Train is initialised with triple-valve in emergency-position. If I release the brake the triple-valve doesn’t switch to release and the train can never be moved.
B)
The initialisation of the AuxRes is wrong if the brakes are initialised fully applied.
With a Pressure of 50psi in the Brakezylinder (brake fully applied), the AuxRes can’t have a pressure of 70psi (which is the max. pressure of the brakesystem) in singlepipe-brakes.
C)
I found in the MSTS-Original 380.eng-file the following error:
TrainBrakesControllerMaxSystemPressure( 70 )
TripleValveRatio( 2.5 )
BrakeCylinderPressureForMaxBrakeBrakeForce( 70 )
The Pressure in the brake cylinder can in this case never go higher then 50psi.
70psi *(3.5)/(2.5)= 50psi
After the initialisation brakecylinder-pressures are higher then 50psi.
(During the Simulation the pressure in the brakezylinder are shown correct.)

[Carlo Santucci (carlosanit1)]

Fixed in x.3984.

[Carlo Santucci (carlosanit1)]

The error in the .eng file is now corrected by OR if the experimental option "Correct questionable braking parameters" is checked.