puller crosses unplated holes
Bug #1550382 reported by
chrysn
This bug affects 1 person
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| pcb |
Fix Released
|
Medium
|
Unassigned | ||
Bug Description
when the puller works on lines that go around an unplated hole, it seems to treat the hole as zero-diameter -- it does not simply snap through it, but only barely avoids the center.
the element i've tested this with contains the pin
Pin[0.0000 0.0000 0.0000 20.00mil 4.4540mm 4.2000mm "" "" "hole"]
which does clear copper eg. in ground planes.
Revision history for this message
| chrysn (chrysn) wrote | #1 |
Revision history for this message
| DJ Delorie (djdelorie) wrote | #2 |
| Changed in pcb: | |
| status: | New → Triaged |
| importance: | Undecided → Medium |
| milestone: | none → next-bug-release |
| Changed in pcb: | |
| status: | Triaged → Fix Committed |
| Changed in pcb: | |
| status: | Fix Committed → Fix Released |
To post a comment you must log in.
the attached file demonstrates the issue when deselecting "Optimize routed tracks" / "Only autorouted nets" and running "Global puller" / "All" on layer "signal2".