GAL ghost and missing ratsnest lines
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
KiCad |
Fix Released
|
High
|
Maciej Suminski |
Bug Description
This bug might be related to #1341714 but it is not exactly the same thing.
Missing lines:
After I finished routing of the board in P&S GAL mode some ground plane ratsnest lines were missing. I resolved it by switching into default that was showing which pads were disconnected on the ground plane and then switching back to GAL to route those lines. After routing the "Unconnected" counter was not decreased until I switched back to default.
Ghost lines:
After getting the "Unconnected" counter to 0 the GAL mode is still showing a few "ghost" lines. They are obviously connected on the copper layer. I could not find any way to get rid of them. I have tried reloading the board, rerouting the trace and switching modes. The ghost lines persist. They are only visible in the GAL modes.
Attached are screenshots of the ghost lines with the polygon pours set to visible and transparent, to show the traces within the polygons.
If needed I can provide the file with these errors privately. :)
tags: | added: cern gal |
Changed in kicad: | |
assignee: | nobody → Maciej Sumiński (orsonmmz) |
importance: | Undecided → High |
Changed in kicad: | |
status: | Fix Committed → Fix Released |
What version of kicad are you using?