no prism54 driver in gutsy

Bug #129537 reported by urho
30
Affects Status Importance Assigned to Milestone
linux-source-2.6.22 (Ubuntu)
Fix Released
High
Unassigned

Bug Description

updated my feisty to gutsy & my wlan card netgear wg511v1 which uses prism54 drivers stopped working. No lights are on & ifconfig wont show wlan0 or any wireless present. lspci other hand gives 02:00.0 Network controller: Intersil Corporation ISL3890 [Prism GT/Prism Duette]/ISL3886 [Prism Javelin/Prism Xbow] (rev 01) so harware is there.

using gutsy Linux version 2.6.22-9-generic (buildd@vernadsky) (gcc version 4.1.3 20070718 (prerelease) (Ubuntu 4.1.2-14ubuntu1)) #1 SMP Mon Jul 30 18:00:27 GMT 2007 (Ubuntu 2.6.22-9.20-generic)

Revision history for this message
urho (vonturha) wrote :
Revision history for this message
urho (vonturha) wrote :
Revision history for this message
urho (vonturha) wrote :
Revision history for this message
Stefano Rivera (stefanor) wrote :

I can confirm this in gutsy/amd64, 2.6.22-9.25

description: updated
Revision history for this message
Stefano Rivera (stefanor) wrote :

$ grep PRISM54 /boot/config-2.6.22-9-generic
# CONFIG_PRISM54 is not set

Changed in linux-source-2.6.22:
assignee: nobody → ubuntu-kernel-team
status: New → Confirmed
Changed in linux-source-2.6.22:
importance: Undecided → High
status: Confirmed → Triaged
Revision history for this message
Typhoe (spamistrash) wrote :

Hi,

it's working again on my laptop!
Using a wep 64 wifi network and a WG511v1.

[ 23.956000] Loaded prism54 driver, version 1.2
[ 23.956000] PCI: Enabling device 0000:03:00.0 (0000 -> 0002)
[ 23.956000] ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [C0C4] -> GSI 11 (level, low) -> IRQ 11
[ 23.956000] prism54: pci_set_mwi(pdev) succeeded
...
[ 38.288000] eth5: resetting device...
[ 38.288000] eth5: uploading firmware...
[ 38.540000] eth5: firmware version: 1.0.4.3
[ 38.540000] eth5: firmware upload complete
[ 38.772000] eth5: interface reset complete

eth5 IEEE 802.11b/g ESSID:"xxx"
          Mode:Managed Frequency:2.422 GHz Access Point: xx:xx:xx....
          Bit Rate:24 Mb/s Tx-Power=31 dBm Sensitivity=20/200
          Retry short limit:8 RTS thr=2347 B Fragment thr=2346 B
          Link Quality=156/0 Signal level=-73 dBm Noise level=-223 dBm
          Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
          Tx excessive retries:0 Invalid misc:0 Missed beacon:0

Thank you very much!

Revision history for this message
Stefano Rivera (stefanor) wrote :

Yes, this is fixed in 2.6.22-10.

Thank you everyone.

Changed in linux-source-2.6.22:
status: Triaged → Fix Released
Revision history for this message
Tim Gardner (timg-tpi) wrote :

I also added the p54 softmac driver to gutsy linux-ubuntu-modules. It will be in the version following
2.6.22-10.24.

modprobe p54usb
modprobe p54pci

Revision history for this message
Alexandre Otto Strube (surak) wrote :

Not fixed for me. I have to change modules just as Tim

Changed in linux-source-2.6.22:
status: Fix Released → Incomplete
Revision history for this message
urho (vonturha) wrote :

works just fine, tested WG511V1 card in two diffrent laptops

Revision history for this message
Leann Ogasawara (leannogasawara) wrote :

Just cleaning up tasks and marking this "Fix Released". Thanks.

Changed in linux-source-2.6.22:
status: Incomplete → Fix Released
Revision history for this message
Launchpad Janitor (janitor) wrote : Kernel team bugs

Per a decision made by the Ubuntu Kernel Team, bugs will longer be assigned to the ubuntu-kernel-team in Launchpad as part of the bug triage process. The ubuntu-kernel-team is being unassigned from this bug report. Refer to https://wiki.ubuntu.com/KernelTeamBugPolicies for more information. Thanks.

To post a comment you must log in.
This report contains Public information  
Everyone can see this information.

Duplicates of this bug

Other bug subscribers

Remote bug watches

Bug watches keep track of this bug in other bug trackers.