[   26.705449] vboxdrv: Found 4 processor cores.
[   26.705593] vboxdrv: fAsync=0 offMin=0x102 offMax=0xf12
[   26.705665] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   26.705667] vboxdrv: Successfully loaded version 4.3.6 (interface 0x001a0007).
[   26.914158] vboxpci: IOMMU not found (not registered)
[   27.301284] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   27.301524] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   27.547246] r8169 0000:03:00.0 eth0: link down
[   27.547280] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   27.547672] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   39.818415] wlan0: authenticate with 08:86:3b:d5:e1:d2
[   39.841635] wlan0: send auth to 08:86:3b:d5:e1:d2 (try 1/3)
[   39.843619] wlan0: authenticated
[   39.845954] wlan0: associate with 08:86:3b:d5:e1:d2 (try 1/3)
[   39.855283] wlan0: RX AssocResp from 08:86:3b:d5:e1:d2 (capab=0x11 status=0 aid=1)
[   39.855321] wlan0: associated
[   39.855331] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   39.855443] cfg80211: Calling CRDA for country: US
[   39.857607] ath: regdomain 0x8348 updated by CountryIE
[   39.857609] ath: EEPROM regdomain: 0x8348
[   39.857610] ath: EEPROM indicates we should expect a country code
[   39.857612] ath: doing EEPROM country->regdmn map search
[   39.857613] ath: country maps to regdmn code: 0x3a
[   39.857614] ath: Country alpha2 being used: US
[   39.857614] ath: Regpair used: 0x3a
[   39.857649] cfg80211: Regulatory domain changed to country: US
[   39.857650] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   39.857651] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   39.857652] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[   39.857653] cfg80211:   (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   39.857654] cfg80211:   (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   39.857655] cfg80211:   (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   39.857656] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[   39.857657] cfg80211:   (57240000 KHz - 63720000 KHz @ 2160000 KHz), (N/A, 4000 mBm)
[ 9545.982363] perf samples too long (2501 > 2500), lowering kernel.perf_event_max_sample_rate to 50000
[ 9571.829082] usb 2-1.2: new high-speed USB device number 4 using ehci-pci
[ 9571.922231] usb 2-1.2: New USB device found, idVendor=0bc2, idProduct=5021
[ 9571.922247] usb 2-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 9571.922255] usb 2-1.2: Product: FreeAgent GoFlex
[ 9571.922263] usb 2-1.2: Manufacturer: Seagate
[ 9571.922270] usb 2-1.2: SerialNumber: NA05ZB1V
[ 9571.991649] usb-storage 2-1.2:1.0: USB Mass Storage device detected
[ 9571.991770] scsi7 : usb-storage 2-1.2:1.0
[ 9571.991855] usbcore: registered new interface driver usb-storage
[ 9572.989262] scsi 7:0:0:0: Direct-Access     Seagate  FreeAgent GoFlex 0148 PQ: 0 ANSI: 4
[ 9572.989683] sd 7:0:0:0: Attached scsi generic sg3 type 0
[ 9572.991208] sd 7:0:0:0: [sdc] 1953525167 512-byte logical blocks: (1.00 TB/931 GiB)
[ 9572.992813] sd 7:0:0:0: [sdc] Write Protect is off
[ 9572.992827] sd 7:0:0:0: [sdc] Mode Sense: 1c 00 00 00
[ 9572.993708] sd 7:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 9573.044507]  sdc: sdc1
[ 9573.047023] sd 7:0:0:0: [sdc] Attached SCSI disk
[ 9576.325597] kjournald starting.  Commit interval 5 seconds
[ 9576.325769] EXT3-fs (sdc1): warning: maximal mount count reached, running e2fsck is recommended
[ 9576.326298] EXT3-fs (sdc1): using internal journal
[ 9576.326303] EXT3-fs (sdc1): mounted filesystem with ordered data mode
[13926.231967] usb 2-1.2: USB disconnect, device number 4
[13926.232958] sd 7:0:0:0: [sdc] Synchronizing SCSI cache
[13926.233066] sd 7:0:0:0: [sdc]  
[13926.233073] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[13955.821070] r8169 0000:03:00.0 eth0: link up
[13955.821079] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[16199.435465] perf samples too long (5043 > 5000), lowering kernel.perf_event_max_sample_rate to 25000
[16558.816290] r8169 0000:03:00.0 eth0: link down
[22951.783678] perf samples too long (10051 > 10000), lowering kernel.perf_event_max_sample_rate to 12500