[   24.700742] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   24.701282] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   24.719095] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   24.722197] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   26.547700] wlan0: authenticate with bc:05:43:51:ca:96
[   26.566427] wlan0: send auth to bc:05:43:51:ca:96 (try 1/3)
[   26.570064] wlan0: authenticated
[   26.572148] wlan0: associate with bc:05:43:51:ca:96 (try 1/3)
[   26.576167] wlan0: RX AssocResp from bc:05:43:51:ca:96 (capab=0x431 status=0 aid=4)
[   26.576215] wlan0: associated
[   26.576242] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   26.861107] init: plymouth-upstart-bridge main process (608) killed by TERM signal
[   27.535369] init: plymouth-stop pre-start process (1042) terminated with status 1
[   28.780761] sit: IPv6 over IPv4 tunneling driver
[   72.088799] SGI XFS with ACLs, security attributes, realtime, large block/inode numbers, no debug enabled
[   72.148120] JFS: nTxBlock = 8192, nTxLock = 65536
[   72.222333] NTFS driver 2.1.30 [Flags: R/O MODULE].
[   72.321502] QNX4 filesystem 0.2.3 registered.
[   72.366747] xor: measuring software checksum speed
[   72.404007]    pIII_sse  :  7794.000 MB/sec
[   72.444008]    prefetch64-sse:  8812.000 MB/sec
[   72.444010] xor: using function: prefetch64-sse (8812.000 MB/sec)
[   72.540027] raid6: mmxx1     2848 MB/s
[   72.608008] raid6: mmxx2     3247 MB/s
[   72.676014] raid6: sse1x1    1735 MB/s
[   72.744018] raid6: sse1x2    2318 MB/s
[   72.812008] raid6: sse2x1    3264 MB/s
[   72.880008] raid6: sse2x2    3699 MB/s
[   72.880010] raid6: using algorithm sse2x2 (3699 MB/s)
[   72.880012] raid6: using ssse3x1 recovery algorithm
[   72.941821] bio: create slab <bio-1> at 1
[   72.944283] Btrfs loaded